SIM LAB GRID MPX Steering Wheel Instructions
- June 13, 2024
- SIM-LAB
Table of Contents
SIM LAB GRID MPX Steering Wheel
Firmware
Currently we are using a separate piece of software designed to work across
multiple devices (Sim-Lab/GRID) to allow for firmware updates.
Unzip the downloaded file ‘updater.zip’ and extract the folder to a location
of your choice, run ‘DeviceUpdater.exe’ to start the software.
- Make sure that no software like Race Director or Sim Hub is running.
- Select your hardware (1) (possibly after clicking ‘Refresh’ (2) when it don’t show up)
- Select the port the hardware is using from the ‘Port selection’ (3) dropdown.
- Begin updating the firmware by pressing ‘Start flash’ (4)
Note: the ‘Start flash’ button will only appear when the appropriate com port has been selected.
Do not close the software, unplug the hardware or turn off your pc. Wait for the software to show the ‘Flashing done’ message.
After this message appeared, you can close the software and reset the hardware. Unplug the USB cable, wait for about two seconds, and plug it back in.
Now you have updated your firmware, you can re-calibrate your hardware where needed and head out on the virtual track again.