SCUDO Momentum Sliding Door with Open End Enclosure Installation Guide

June 1, 2024
SCUDO

SCUDO Momentum Sliding Door with Open End Enclosure

SCUDO-Momentum-Sliding-Door-with-Open-End-Enclosure-
product

Specifications

  • Product: Momentum Sliding Door with Open End Enclosure
  • Installation Date: 09/23

Product Usage Instructions

Before You Start:

Assemble the enclosure according to the provided instructions to ensure stability. Check all accessory quantities upon opening the carton.

Tools and Materials Required:

  • Level
  • Screwdriver
  • Silicone
  • Tape Measure
  • Pencil
  • Soap
  • Caulk Gun & Silicone
  • Drill & Bits
  • Rubber Mallet
  • Handsaw

Installation Steps:

  1. Ensure the shower tray is level in all directions and properly sealed to the wall.
  2. Tile the wall down to the top edge of the tray without angling out the bottom tile.
  3. Saw off the wall facing end as instructed.
  4. Insert the sliders using the cut-out area.

Cleaning Instructions:

Cleaning Type Procedure Cleaning Interval
Routine Cleaning – Transparent Glass Rinse with warm and then cold water. Dry

with a squeegee
immediately after showering.| Weekly or monthly, according to user preferences.
Routine Cleaning – Glass with Easy-Clean Treatment| Clean with water and diluted vinegar. Rinse with clean water.
Dry with a squeegee.| Weekly or monthly, according to user preferences.
Main Cleaning| Use water or vinegar, dry with a squeegee or puliment.| Weekly or monthly, according to user preferences.

Maintenance of Mechanical Parts:

Mechanical parts of the screen should be lightly lubricated for optimal function. Tighten visible screws as needed for maintenance.

Easy-Clean Coating:

The easy-clean coating prevents water droplets, soap dirt, or limescale from adhering to the glass. Use non-abrasive cloths and cleaning agent for cleaning.

FAQ

  • Q: What should I do if I find missing fittings during installation?
    • A: Contact customer support immediately to request the missing fittings for proper assembly.
  • Q: How often should I perform main cleaning on the enclosure?
    • A: Main cleaning can be done weekly or monthly, depending on your cleaning preferences and usage frequency.

BEFORE YOU START

IMPORTANT NOTICE

Please assemble according to our instructions, otherwise the enclosure will not be stable. Please check accessory quantities after you open the carton to ensure all fittings are included.

IMPORTANT NOTICE

Trat must be sealed fully around where the tray meets the wall. Tray must be 100% level in all directions. Ensure the shower tray is level in all directions and is properly sealed to the wall. The wll must be tiled down to the top edge of the tray. Do not angle out bottom tile.

TOOLS AND MATERIALS REQUIRED

SCUDO-Momentum-Sliding-Door-with-Open-End-
Enclosure-fig \(3\)

TOOLS & MATERIALS SUPPLIED

Note! Additional tools and materials may be necessary, depending on the specific requirements of the site.SCUDO-Momentum-Sliding-Door-with-Open-End-
Enclosure-fig \(4\) SCUDO-Momentum-
Sliding-Door-with-Open-End-Enclosure-fig \(5\)SCUDO-Momentum-Sliding-Door-with-Open-End-Enclosure-fig
\(6\)

Installation Instruction

SCUDO-Momentum-Sliding-Door-with-Open-End-Enclosure-fig
\(7\) SCUDO-Momentum-Sliding-Door-with-
Open-End-Enclosure-fig \(8\) SCUDO-
Momentum-Sliding-Door-with-Open-End-Enclosure-fig \(9\) SCUDO-Momentum-Sliding-Door-with-Open-End-Enclosure-fig
\(10\) SCUDO-Momentum-Sliding-
Door-with-Open-End-Enclosure-fig \(11\)

SCUDO-Momentum-Sliding-Door-with-Open-End-Enclosure-fig
\(12\)

IMPORTANT FOR PROPER CLEANING

Your shower enclosure is designed for minimum cleaning effort. In order to keep your shower enclosure permanently shining, a few rules must be observed.: Profiles and glass may only be cleaned with light cleaning agents. Abrasive cleaning agents, alcohol or nitric solutions must not be used. Do not use steel wool or course microfibre cloths for cleaning, as this will cause scratches. limescale in the water causes satins, so frequent cleaning is essential to keep your screen clean. The longer the limescale remains, the more difficult it is to remove.

MAINTENANCE OF MECHANICAL PARTS

The mechanical parts of the screen also need maintenance to ensure that they will function perfectly for many years to come. The bearings and hinged parts of the screen should be lightly lubricated. Screws that remain visible should also be tightened.

EASY-CLEAN COATING

The easy-clean coating is a special treatment that gives the glass an extra- smooth surface coating that prevents water droplets, soap dirt or limescale from adhering to the glass. Cleaning is not prevented, but all residues are easily and effortlessly removed. To clean the easy-clean coated glass surface, non-abrasive cloths and cleaning agent should be used.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals