ANSMANN LED Strip Sensor User Manual
- June 3, 2024
- ANSMANN
Table of Contents
BEDIENUNGSANLEITUNG
USER MANUAL
LED STRIP SENSOR
LED Strip Sensor
SAFETY – EXPLANATION OF NOTES
Please take note of the following symbols and words used in theoperating
instructions, on the product and on the packaging:
= Information | Useful additional information about the product
= Note | The note warns you of possible damage of all kinds
= Caution | Attention – Hazard can lead to injuries
** = Warning** | Attention – Danger! May result in serious injury or
death
**** GENERAL SAFETY INSTRUCTIONS
This product may be used by children from the age of 8 and by persons with
reduced physical, sensory or mental abilities or lack of experience and
knowledge, if they have been instructed on the safe use of the product and are
aware of the hazards. Children are not permitted to play with the product.
Children are not permitted to carry out cleaning or care without supervision.
Keep the product and the packaging away from children. This product is not a
toy. Children should be supervised in order to ensure that they do not play
with the product or packaging.
Avoid eye injuries – Never look directly into the beam of light or shine it
into other people‘s faces. If this occurs for too long, the blue light portion
of the beam can cause retinal damage.
Do not expose to potentially explosive environments where there are flammable
liquids, dusts or gases. Never submerge the product inwater or other liquids.
All illuminated objects must be at least 5cm away from the lamp. Use the
product exclusively withthe accessories included with it. Improperly inserted
batteries could leak and/or cause a fire/explosion.
Keep batteries away from children:Risk of choking or suffocating.
Never try to open, crush or heat a standard/rechargeable battery or set it on
fire. Do not throw into a fire.
When inserting batteries, ensure that the batteries are inserted with the
correct polarity.
Leaking battery fluid can cause irritation if it comes into contact with the
skin. Immediately rinse affected areas with fresh water and then seek medical
attention.
Do not short-circuit connection terminals or batteries.
Do not attempt to charge nonrechargeable batteries.
Rechargeable batteries must only be charged under the supervision of an adult
and must be removed from the device before being charged.
**** DANGER OF FIRE AND EXPLOSION
Do not use while still in the packaging.
Do not cover the product – risk of fire.
Never expose the product to extreme conditions, such as extreme heat/cold etc.
Do not use in the rain or in damp areas.
**** GENERAL INFORMATION
- Do not throw or drop.
- The LED cover cannot be replaced. If the cover is damaged, the product must be disposed of.
- The LED light source cannot be replaced. If the LED has reached the end of its service life, the complete lamp must be replaced.
- Do not open or modify the product! Repair work shall only be carried out by the manufacturer or by a service technician appointed by the manufacturer or by a similarly qualified person.
- The lamp shall not be placed face-down or allowed to topple face-down.
**BATTERIES**
- Always change all of the batteries at the same time as a complete set and always use equivalent batteries.
- Do not use batteries if the product appears to be damaged.
- Batteries are not rechargeable. Do not short-circuit batteries.
- Switch the product off before changing the batteries.
- Remove used or empty batteries from the lamp immediately.
**ENVIRONMENTAL INFORMATION | DISPOSAL**
Dispose of packaging after sorting by material type. Cardboard and cardboard
to the waste paper, film to the recycling collection.
Dispose of the unusable product in accordance with legal provisions. The
„waste bin“ symbol indicates that, in the EU, it is not permitted to dispose
of electrical equipment in household waste. Use the return and collection
systems in your area or contact the dealer from whom you purchased the
product. For disposal, pass the product on to a specialist disposal point for
old equipment. Do not dispose of the device with household waste!
**** Always dispose of used batteries & rechargeable batteries in accordance
with the local regulations and requirements. In this way you will fulfil your
legal obligations and contribute to environmental protection.
PRODUCT DESCRIPTION
- Control unit
- Sensor
- Rotary wheel
- Battery compartment
- Orientation light
- Charge socket
- Switch
- Double-sided adhesive tape
- LED strip
- Adhesive tape
FIRST USE
- Connect the LED strip to the control unit. Pressing the orientation light activates or deactivates the light.
- Slide switch on the side activates (moon) or deactivates (sun) the twilight mode.
- Lighting duration control can be adjusted using the dial.
- We recommend using 4× AAA batteries. However, the light can also be operated directly via the Micro USB port.
**** The product complies with the requirements from the EU directives.
Subject to technical changes. We assume no liability for printing errors.
Customer service:
ANSMANN AG
Industriestrasse 10
97959 Assamstadt
Germany
Hotline: +49 (0) 6294 / 4204 3400
E-Mail: hotline@ansmann.de
MA-1600-436/V1/06-2021
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>