BUFFALO CJ799 Quartz Salamander Grill Instruction Manual

Quartz Salamander Grill
Instruction manual

Model
CJ799

Safety instructions

Position on a flat, stable surface.

• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.

• Consult Local and National Standards to comply with the

• Consult Local and National Standards to comply with the  following:
  – Health and Safety at Work Legislation
  – BS EN Codes of Practice
  – Fire Precautions
  – IEE Wiring Regulations
  – Building Regulations

• Some surfaces become hot during operation – take care when using the appliance.

• DO NOT immerse the appliance in water.

• DO NOT clean with jet/pressure washers.

•  DO NOT carry when hot.

• DO NOT leave the appliance unattended during operation.

• DO NOT obstruct or cover the appliance in any way when in use.

• During and after cooking, the unit is still hot. Never touch the surface to avoid scalding.

• Not suitable for outdoor use.

• Always switch off and disconnect the power supply to the appliance when not in use.

• This appliance must only be used in accordance with these instructions and by persons competent to do so.

• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.

• If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid a hazard.

• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

• Children should be supervised to ensure that they do not play with the appliance.

• BUFFALO recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection, Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.

• BUFFALO recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Introduction

Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.

Pack Contents
The following is included:

• BUFFALO Quartz Salamander Grill
• Grill Rack
• Crumb Tray
• Instruction manual

BUFFALO prides itself on quality and service, ensuring that at the time of unpacking the contents are supplied fully functional and free of damage.
Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Installation

1. Place the unit on a heat-resistant surface. Avoid placing it on or close to flammable materials.
   Maintain a distance of 20cm (7 inches) between the appliance and walls or other objects for ventilation.

2. Keep the unit away from splashing water and countertop’s edge.

Note: Before using for the first time, clean the interior and grill rack with soapy water. Let dry completely.

Operation

1. the crumb tray and upper splash guard are in place.

2. Slide the grill rack in place. Add food afterwards.

3. Connect the appliance to the mains power supply.

4. Use the element control switch to select between upper element , lower element or both elements .

5. Set the timer to the desired cooking time. The timer can be adjusted any time during operation.

6. When the set time expires, the timer sounds an audible alarm and goes back to “0” automatically.
   Note: The timer is just a reminder. Even after it returns to “0”, the appliance is still running.

7. After use, ensure to switch the appliance off by setting the element control switch to “OFF”.
   Then disconnect from the power supply.

Cleaning, Care & Maintenance

Warning:
Always turn off and disconnect the appliance from the power supply before cleaning.
Always allow the appliance to cool before cleaning.

• Clean the interior of the appliance as often as possible.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• For stains on the interior walls, wipe with a cloth damped with some mild soapy solution. Ensure no moisture enters the inside of the cabinet.
• Always wipe dry after cleaning.

Cleaning the grill rack

• After use, remove the grill rack from the appliance for cleaning.
• Clean using warm, soapy water. Rinse thoroughly and dry well.
• Re-locate into the appliance.

Crumb Tray

• Periodically remove the crumb tray and empty.
• Clean the crumb tray using warm, soapy water.
• Re-locate into the appliance.

WARNING: DO NOT remove the tray during or immediately after use as it is still hot.

Troubleshooting

A qualified technician must carry out repairs if required.

plugged in correctly and switched on
Plug or lead is damaged| Replace plug or lead
Fuse in the plug has blown| Replace the fuse
Mains power supply fault| Check mains power supply
Appliance heats up but indicator light does not come on| Indicator light has expired| Consult a qualified technician
Appliance does not heat up| Faulty heating elements| Consult a qualified technician
Faulty control knobs| Consult a qualified technician
Appliance slow to heat up| Faulty heating elements| Consult a qualified technician

Technical Specifications

Due to our continuing program of research and development, the specifications herein may be subject to change without notice.

Model| Voltage| Power| Current| Dimensions
HxWxDmm| Weight
---|---|---|---|---|---
C3799| 220-240W∼
50-60Hz| 3000W| 13A| 311 x 640 x 360| 15.

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.

This appliance is wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

**** This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance
**** The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international, independent, and federal authorities.
BUFFALO products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

• Conformiteitsverklaring

Application of Territory Legislation & Council Directives(s)

• Application de la/des directive(s) du Conseil

| Low Voltage Directive (LVD) – 2014/35/EU
Electrical Equipment (Safety) Regulations 2016
BS EN 60335-1:2012 +A11:2014 +A13:2017 +A1:2019 +A14:2019
BS EN 60335-2-48:2003 +A1:2008 +A11:2012 +A2:2019
BS EN 62233:2008 Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU – recast of 2004/108/EC
Electromagnetic Compatibility Regulations 2016 (S.I. 2016/1091)
BS EN IEC 55014-1: 2021
BS EN IEC 55014-2: 2021
BS EN IEC 61000-3-2: 2019 +A1:2021
BS EN 61000-3-3: 2013 +A1:2019 +A2:2021

Restriction of Hazardous Substances Directive (RoHS) 2015/863 amending Annex II to
Directive 2011/65/EU
Restriction of the Use of Certain Hazardous Substances in Electrical and Electronic
Equipment Regulations 2012 (S.I. 2012/3032)

Producer Name| Buffalo

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

Unit 9003, Blarney Business Park,
Blarney,  Co. Cork
Ireland

Eire
NL| 040 – 2628080
FR| 01 60 34 28 80
BE-NL| 0800-29129
BE-FR| 0800-29229
DE| 0800 – 1860806
IT| N/A
ES| 901-100 133

http://www.buffalo-appliances.com/
CJ799_ML_A5_v1_2023/07/07

CJ799_ML_A5_v1 20230707.indb 36

Documents / Resources

| BUFFALO CJ799 Quartz Salamander Grill [pdf] Instruction Manual
CJ799 Quartz Salamander Grill, CJ799, Quartz Salamander Grill, Salamander Grill, Grill
---|---

References

• Buffalo Home Page

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>