KUZCO WS74114 LED Wall Sconce Installation Guide
- June 4, 2024
- KUZCO
Table of Contents
KUZCO WS74114 LED Wall Sconce
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
- 120V input
- Remove fixture from its original package
- Separate mounting plate (1c) from the canopy (2a) by removing canopy screws (2b)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in the hardware package
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package, and then place driver (4a) inside junction box (1a)
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2b)
- Secure pendant tube (3b) to pendant holder (3a) by threading clockwise
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>