KUZCO VM30348-5CCT LED Vanity Mirror Owner’s Manual

KUZCO VM30348-5CCT LED Vanity Mirror

Specifications

• Product Name: LED Vanity Mirror
• Model Number: VM30348-5CCT
• Manufacturer: Kuzco Lighting
• Technical Support: 1-855-855-8926

Product Usage Instructions:

Installation:

1. Remove the mirror from its original package.
2. Measure and mark the location of the wall bracket (2a), then mount it to the wall using screws (2c) and anchors (2b). Ensure all screws are attached directly to a stud or structure.
3. Make proper electrical connections by connecting black to hot L, white to neutral N, and ground to GND using wire nuts (1a) provided in the hardware package to an ON/OFF wall switch (wall switch not included).
4. Bend both wall bracket (2a) tabs back to prevent the mirror from sliding side to side. Align the mirror mounting bracket to the wall bracket to secure it.

Operation:

1. Tap the mirror switch (3b) to choose the color temperature and hold it to dim up and down.
2. Use the wall ON/OFF switch to ensure proper operation of the LED mirror.

FAQ:

• Q: What should I do if the LED mirror is not turning on?
  A: Ensure that the electrical connections are properly made according to the provided instructions. Check if the wall ON/OFF switch is in the ON position.

• Q: Can I mount the mirror vertically?
  A: Yes, you can mount the mirror either horizontally or vertically. Refer to Illustration 3 for ideal distance measurements for drill holes based on mirror orientation.

VM30348-5CCT
INSTALLATION SHEET

LED Vanity Mirror

START FROM HERE

• Make sure POWER is COMPLETELY OFF at the fuse box
• Have your mirror installed by a certified licensed electrician
• Prepare everything in a clear area
• Wear gloves at all times during this installation
• Read instructions carefully before you start assembly
• Keep this installation sheet for future reference

Important:
The installer and/or user must read, understand and follow these instructions before installing the product. This product must be properly installed before it is used. If instructions are not followed, the manufacturer will not be held responsible for any problems or product malfunction. Failure to follow installation and/or operating instructions voids the warranty.

Technical Support : 1-855-855-8926

Please Note:

• This Kuzco LED mirror comes with pre-wired LED module(s)
• Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
• For Indoor Use Only
• Touch Dimming
• Do not use alcohol or solvents to clean the mirror
• For your convenience, assembly by two people is a must

Installation

1. Remove mirror from its original package

2. Measure, mark location of wall bracket (2a) location, mount to wall with screws (2c) and anchors (2b) (See Illustration 3 for ideal distance measurement) (Note: All screws must be attached directly to stud/structure)

3. Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1a) provided in hardware package to ON/OFF wall switch (wall switch provided by others)
   NOTE : Wall ON/OFF Switch must be used to ensure proper operation of LED mirror

4. Bend both wall bracket (2a) tabs back to prevent mirror from sliding side to side (See Illustration 2). Align mirror (3a) mounting bracket to wall bracket (2a) to secure (See Illustration 1)

5. Tap mirror switch (3b) to choose color temperature and hold to dim up and down

19054 28th Avenue Surrey, BC Canada V3Z 6M3
T : 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196 W: kuzcolighting.com
20240109

References

• Kuzco Lighting – Modern Contemporary Lighting.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>