KUZCO WS90416 Mason LED Wall Sconce Installation Guide
- June 1, 2024
- KUZCO
Table of Contents
KUZCO WS90416 Mason LED Wall Sconce
LED Wall Sconce
Specifications
- Model: WS90416
- Input Voltage: 120V
- Power Consumption: 12W
- Color Temperature: 3000K
- Luminous Flux: 900 lumens
- Dimmable: Yes
- Material: Metal and Glass
- Dimensions: 10″ x 5″ x 3″
Product Usage Instructions
Unboxing and Preparation:
Remove the LED wall sconce from its original packaging ensuring all
components are included.
Mounting
- Separate the mounting plate from the canopy by removing the canopy screws.
- Make proper electrical connections:
- Black wire to hot (L)
- White wire to neutral (N)
- Ground wire to GND
- Attach the mounting plate to the electrical junction box using the provided junction box screws.
- Connect the canopy to the mounting plate using the canopy screws.
Final Steps
Ensure all connections are secure and test the light fixture before
completing the installation process.
Frequently Asked Questions (FAQ)
-
Q: Is this LED wall sconce suitable for outdo or use?
A: This LED wall sconce is rated for indoor use only. Do not expose it to direct water or extreme weather conditions. -
Q: Can this wall sconce be dimmed?
A: Yes, this LED wall sconce is dimmable. Ensure to use a compatible dimmer switch for optimal performance.
LED Wall Sconce
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
- 120V input
Technical Support: 1-855-855-8926
- Remove fixture from its original package
- Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b)
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in hardware package
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2b)
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196 W:
kuzcolighting.com
20240206