KUZCO VL55529 LED Vanity Light Instruction Manual
- June 1, 2024
- KUZCO
Table of Contents
KUZCO VL55529 LED Vanity Light
Specifications:
- Product: LED Vanity Light
- Model: VL55529
Product Usage Instructions
Removal from Package:
Remove the fixture from its original package carefully to avoid any damage.
Mounting Plate Separation:
Separate the mounting plate (1c) from the canopy (2a) by removing the
canopy screws (2b).
Mounting Plate Attachment:
Attach the mounting plate (1c) to the electrical junction box (1a) using
the junction box screws provided (1e) in the hardware package.
Electrical Connections:
Make proper electrical connections by connecting black to hot L, white to
neutral N, and ground to GND using the wire nuts (1b) provided in the hardware
package.
Canopy Attachment:
Attach the canopy (2a) to the mounting plate (1c) with the canopy screws
(2b).
Shade Attachment:
Attach the shade (3b) to the fixture (3a) by threading it clockwise to
secure it in place.
FAQ:
Q: What should I do if the LED Vanity Light does not turn on after
installation?
A: Make sure all connections are secure and that the wiring is correctly done
following the provided instructions. Check the power source and ensure it is
functioning properly.
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
- 120V input
Technical Support: 1-855-855-8926
INSTALLATION
- Remove the fixture from its original package
- Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in hardware package
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2b)
- Attach shade (3b) to fixture (3a) by threading clockwise to secure
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162
TF: 1-855 85 KUZCO
F : 604 538 7196
W: kuzcolighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>