KUZCO PD50852 Ceiling LED Pendant Installation Guide
- October 27, 2023
- KUZCO
Table of Contents
KUZCO PD50852 Ceiling LED Pendant
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
- 120V input
Technical Support: 1-855-855-8926
INSTALLATION
- Remove the fixture from its original package
- Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in the hardware package
- To change fixture height, shorten or lengthen wire by removing set screw (3a) with allen key from canopy (2a) and push or pull wire to your desired length. Secure set screw (3a) with allen key in canopy (2a) to lock wire in place
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package and place driver (4a) inside canopy (2a)
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2b)
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196 W:
kuzcolighting.com
20210526
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>