KUZCO VL28028 Braga LED Vanity Light Installation Guide
- June 1, 2024
- KUZCO
Table of Contents
KUZCO VL28028 Braga LED Vanity Light
Product Information
Specifications:
- Product: LED Vanity Light
- Model: VL28028
- Manufacturer: Kuzco
- Technical Support: 1-855-855-8926
Product Usage Instructions
Installation Steps:
- Remove the fixture from its original package.
- Separate the mounting plate (1c) from the canopy (2a) by removing the canopy screws (2b).
- Attach the mounting plate (1c) to the electrical junction box (1a) using the junction box screws provided (1e) in the hardware package.
- Make proper electrical connections (black to hot L, white to neutral N, ground to GND) with wire nuts (1b) provided in the hardware package and place the driver (4a) in the canopy (2a).
- Secure the shade (3b) to the fixture body (3a), followed by the shade cap (3c) by threading clockwise.
- Attach the canopy (2a) to the mounting plate (1c) with canopy screws (2b).
FAQ
-
Where can I find technical support for this product?
You can contact technical support at 1-855-855-8926 for assistance with any product-related queries or issues. -
What should I do if I encounter difficulties during installation?
If you face challenges during installation, refer to the installation sheet provided or contact technical support for guidance.
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application
- 120V input
INSTALLATION INSTRUCTION
- Remove fixture from its original package
- Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in hardware package
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package and place driver (4a) in canopy (2a)
- Secure shade (3b), to fixture body (3a), followed by shade cap (3c) by threading clockwise
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2b)
ABOUT COMPANY
- 19054 28th Avenue Surrey, BC Canada V3Z 6M3
- T: 604 538 7162
- TF: 1-855 85 KUZCO
- F: 604 538 7196
- W: kuzcolighting.com
- 20240109
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>