KUZCO WS90717 LED Wall Sconce User Guide
- October 27, 2023
- KUZCO
Table of Contents
KUZCO WS90717 LED Wall Sconce
START FROM HERE
- Make sure the POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start the assembly
- Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
- This Kuzco LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ELV (Electronic Low Voltage) type of dimmer is required
- 120V input
INSTALLATION INSTRUCTION
- Remove fixture from its original package
- Separate mounting plate (1c) from canopy (2a) and fixture backplate (3a) by removing backplate screws (3b)
- Attach mounting plate (1c) to electrical junction box (1a) using junction box screws (1e) provided in hardware package
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package
- Attach fixture backplate (3a) to canopy (2a) and mounting plate (1c) with backplate screws (3b) (Optional: can fine-tune orientation of fixture backplate to the canopy)
- Attach fixture (3c) to fixture backplate (3a) with fixture screws (2b)
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162 TF: 1-855 85 KUZCO F: 604 538 7196
W: kuzcolighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>