KUZCO 601432-LED LED Lamp Wall Sconce Installation Guide
- June 4, 2024
- KUZCO
Table of Contents
KUZCO 601432-LED LED Lamp Wall Sconce
LED Lamp Wall Sconce
-
Remove the fixture from its original packaging. Remove the canopy mounting plate from within the canopy and attach it to the electrical junction box, and wall, using the screws provided in the hardware package.
-
Attach the canopy to the mounting plate, which is attached to the electrical junction box on the wall. First attach all wiring with the provided marrets (white to white “N”, black to black “L”, ground to ground “G”). Push the canopy onto the mounting plate, then insert the locking screws into the
hole on the top and bottom of the canopy, once inserted, screw in the screws to secure the fixture to the wall. -
You have now completed the installation of your fixture, please enjoy.
INSTALLATION SHEET
START FROM HERE
- Make sure power is completely off at the fuse box.
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in clear area.
- Wear gloves at all times during this installation.
- Read instructions carefully before you start assembly.
- Keep this instruction sheet for future reference.
Technical Support: 1-855-855-8926
Please Note:
- All Kuzco LED fixtures come with pre-wired LED module(s).
- Unless instructed to do so, please do not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage.
- For dimming, an ELV (Electronic Low Voltage) dimmer is required.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>