KUZCO FM80724 LED Flush Mount Installation Guide
- June 4, 2024
- KUZCO
Table of Contents
KUZCO FM80724 LED Flush Mount Installation Guide
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- All Kuzco LED fixtures come with pre-wired LED module(s).
- Unless instructed to do so, please do not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage.
- For dimming, an ELV (Electronic Low Voltage) type of dimmer is required.
Technical Support: 1-855-855-8926
Overview
- Remove the fixture from its original packaging. Next, remove the mounting plate (1c) from within the canopy (2a) by un-threading the screws (2b). Attach the mounting plate (1c) to the electrical junction box (1a) by using the two screws (1e) provided in the hardware package. Make sure to reinforce the wood behind the ceiling and use the wood screws and plastic anchors (1d) provided.
- You are now ready to mount the canopy. First connect all wires correctly black to black “L”, white to white “N” and the ground wire with provided marrets (1b) from the hardware package. Align the canopy (2a) to the mounting plate (1c) up against the ceiling. Secure the canopy by using the screws (2b) provided.
- You have now completed the installation of your fixture, enjoy.
19054 28th Avenue Surrey,
BC Canada V3Z 6M3
T: 604 538 7162
TF: 1-855 85 KUZCO
F: 604 538 7196
W: kuzcolighting.com
20181127
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>