KUZCO VL94826 LED Vanity User Guide
- June 4, 2024
- KUZCO
Table of Contents
KUZCO VL94826 LED Vanity
START FROM HERE
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all time during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Technical Support: 1-855-855-8926
Please Note:
- This Kuzco LED fixtures come with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- Use ELV (Electronic Low Voltage) or TRIAC type of dimmer for dimming application.
Mounting Fixture
- Remove fixture from its original package
- Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2f)
- Attach mounting plate (1c) to electrical junction box (1a) using screws provided (1e) in hardware package
- Secure mounting plate (1c) to mounting surface with additonal screws (1h)
- Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package
- Align mounting plate (1c) to holes on canopy (2a), and then attach using canopy screws (2f)
19054 28th Avenue Surrey, BC Canada V3Z 6M3
T: 604 538 7162
TF: 1-855 85 KUZCO
F: 604 538 7196
W: kuzcolighting.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>