aLora WV348118 Edwin 13W LED Bath Vanity User Guide
- June 13, 2024
- aLora
Table of Contents
aLora WV348118 Edwin 13W LED Bath Vanity
Product Information
- Product Name: WV348118 Wall Lamp
- Technical Support: 1.855.855.8926, technicalsupport@aloralighting.com
- Manufacturer: Alora Lighting
- Manufacturer Address: Canada – 19054 28th Avenue Surrey, BC V3Z 6M3; USA – 3035 E. Lone Mountain Rd, Las Vegas, NV, 89081
- Website: www.aloralighting.com
- Product Code: WV348118
Warnings and Cautions
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- Read and follow all instructions before installation and use.
- Ensure that the electrical junction box is properly installed and compatible with the fixture.
- Make sure to turn off the power supply before installing or servicing the fixture.
- Do not exceed the maximum wattage specified for the fixture.
- Use only the recommended type and wattage of light bulbs.
- This Alora LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
- 120V input
NOTICE
- The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
- This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
ASSEMBLY INSTRUCTIONS
-
Step 1
Remove fixture from its original package. -
Step 2
Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b). -
Step 3
Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in hardware package. -
Step 4
Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package and place driver (4a) in electrical junction box (1a). -
Step 5
Secure glass (3b) to fixture body (3a) by threading clockwise. -
Step 6
Attach canopy (2a) to mounting plate (1c) with canopy screws (2b).
You are now ready to enjoy your fixture.
TECHNICAL SUPPORT
1.855.855.8926
technicalsupport@aloralighting.com
P: 1.855.855.8926
CANADA: 19054 28th Avenue Surrey – BC V3Z 6M3
USA: 3035 E. Lone Mountain Rd – Las Vegas, NV, 89081
www.aloralighting.com
20230619
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>