aLora WV348218 Willard 2 Light Bath Vanity User Guide

Table of Contents

aLora-WV348218-Willard-2-Light-Bath-Vanity-product

Step 1: Remove the wall lamp fixture from its original package.
Step 2: Separate the mounting plate (1c) from the fixture (2a) by removing the decorative nuts (2c).
Step 3: Align the mounting plate screws (1d) to the desired orientation and attach the mounting plate (1c) to the electrical junction box (1a) using the junction box screws provided (1e) in the hardware package.
Step 4: Secure the mounting plate (1c) to the mounting surface with anchors (1f) and screws (1g).
Step 5: Make proper electrical connections by connecting the black wire to hot L, the white wire to neutral N, and the ground wire to GND. Use the wire nuts (1b) provided in the hardware package.
Step 6: Align and insert the mounting plate screws (1d) through the holes on the fixture (2a) and secure them with the decorative nuts (2c).
Step 7: Install the recommended lamp (4a) to the fixture socket. Please refer to the socket label for the maximum wattage and type of lamp to use. Attach the glass (3c) to the fixture (2a), followed by the decorative end (3b), and secure them with the screw (3a).

You are now ready to enjoy your wall lamp fixture.

Technical Support:

For any technical support, please contact:

Contact Information:

Please Note:

NOTICE

The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.

Step 1
Remove the fixture from its original package.
Step 2
Separate mounting plate (1c) from fixture (2a) by removing decorative nuts (2c).
Step 3
Align mounting plate screws (1d) to desired orientation, and then attach a mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in the hardware package
Step 4
Secure the mounting plate (1c) to the mounting surface with anchors (1f) and screws (1g).
Step 5
Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package.
Step 6
Align and insert mounting plate screws (1d) through holes on the fixture (2a), secure with decorative nuts (2c)
Step 7
Install the recommended lamp (4a) (not provided) (referred to on the socket label for maximum wattage and type) to the fixture socket. Attach glass (3c) to fixture (2a), followed by the decorative end (3b), and secure with screw (3a).
You are now ready to enjoy your fixture.