aLora CH347346 Osorio LED Chandelier Installation Guide

Table of Contents

aLora-CH347346-Osorio-LED-Chandelier-PRODUCT

Please Note: Read and follow all instructions before installation and usage of this chandelier.

Remove the chandelier from its original package.
Separate the mounting plate (1c) from the canopy (2a) by removing the canopy screws (2b).
Attach the mounting plate (1c) to the electrical junction box (1a) using the junction box screws provided (1e) in the hardware package.
Determine the hanging height of the fixture by securing rods (2d) to the canopy (2a) and fixture hub (3a) after feeding the fixture wires (LED+ and LED-) through the rods.
Make proper electrical connections between LED and DC driver, LED Negative, LED Positive, with wire nuts provided (See Illustration 1 and refer to the diagram on the driver).
Make proper electrical connections (black to hot L, white to neutral N, ground to GND) with wire nuts (1b) provided in the hardware package and place the driver (4a) in the canopy (2a).
Secure the filament (5c) to the fixture arm (5b) by threading clockwise. Attach the filament end (5d) to the filament (5c) with the end cap (5e). Align the holes on the fixture arm (5b) and filament end (5d) with the holes on the shade (6b), and secure them with screws (6a).
Attach the canopy (2a) to the mounting plate (1c) with the canopy screws (2b).

You are now ready to enjoy your chandelier.

WARNINGS AND CAUTIONS

Please Note

This Alora LED fixture comes with pre-wired LED module(s)
Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
120V input

NOTICE

The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.

aLora-CH347346-Osorio-LED-Chandelier-FIG-1

Step 1: Remove fixture from its original package.
Step 2: Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b).
Step 3: Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in hardware package.
Step 4: Determine hanging height of fixture by securing rods (2d) to canopy (2a) and fixture hub (3a) after feeding fixture wires (LED+ and LED-) through rods.
Step 5: Make proper electrical connections between LED and DC driver, LEDNegative, LED+ Positive, with wire nuts provided (See Illustration 1 and refer to diagram on driver).
Step 6: Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in hardware package and place driver (4a) in canopy (2a).
Step 7: Secure filament (5c) to fixture arm (5b) by threading clockwise. Attach filament end (5d) to filament (5c) with end cap (5e). Align holes on fixture arm (5b) and filament end (5d) with holes on shade (6b), secure with screws (6a).
Step 8: Attach canopy (2a) to mounting plate (1c) with canopy screws (2b).