alora WV321628 LED Bath Vanity Wall Lamp Instructions
- June 13, 2024
- aLora
Table of Contents
WV321628 LED Bath Vanity
Wall Lamp Instructions
WV321628
Wall Lamp
WARNINGS AND CAUTIONS
- Make sure POWER is COMPLETELY OFF at the fuse box
- Have your fixture installed by a qualified licensed electrician
- Prepare everything in a clear area
- Wear gloves at all times during this installation
- Read instructions carefully before you start assembly
- Keep this installation sheet for future reference
Please Note:
- This Alora LED fixture comes with pre-wired LED module(s)
- Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
- For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
- 120V input
NOTICE
- The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
- This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture to the outlet box may make it impossible to correctly align the fixture.
ASSEMBLY INSTRUCTIONS
Step 1
Remove fixture from its original package.
Step 2
Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b).
Step 3
Attach mounting plate (1c) to electrical junction box (1a) using junction box
screws provided (1e) in hardware package.
Step 4
Secure mounting plate (1c) to mounting surface with anchors (1f) and screws
(1g)
Step 5
Attach support cables (5a) to back of canopy (2a).
Step 6
Make proper electrical connections (black to hot “L”, white to neutral “N”,
ground to “GND”) with wire nuts (1b) provided in hardware package and place
driver (4a) in canopy (2a).
Step 7
Secure canopy (2a) to mounting plate (1c) with canopy screws (2b).
You are now ready to enjoy your fixture.
TECHNICAL SUPPORT
1.855.855.8926
technicalsupport@aloralighting.com
CANADA :
P: 1.855.855.8926
19054 28th Avenue Surrey – BC V3Z 6M3
USA : 3035 E. Lone Mountain Rd – Las Vegas, NV, 89081
www.aloralighting.com
20230619
Documents / Resources
|
alora WV321628 LED Bath Vanity Wall
Lamp
[pdf] Instructions
WV321628, WV321628NB, WV321628 LED Bath Vanity Wall Lamp, WV321628, LED Bath
Vanity Wall Lamp, Vanity Wall Lamp, Wall Lamp, Lamp
---|---
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>