alora PD336507 Pendant 8 Inch Wide LED Multi Light Instruction Manual

Table of Contents

alora-PD336507-Pendant-8-Inch-Wide-LED-Multi-Light-
PRODUCT

Warnings and Cautions:

Caution and certain care factors must be followed for safety.
It is highly recommended that a licensed, trained electrician install this unit.
The fixture should be mounted securely to the building structure using a junction box or octagon box with a plaster frame.
The supplied crossbar and hardware should be used for mounting to ensure the correct alignment of the fixture.

Assembly Instructions:

Step 1: Remove the fixture from its original package.
Step 2: Separate the mounting plate (1c) from the canopy (2a) by removing the canopy screws (2b).
Step 3: Attach the mounting plate (1c) to the electrical junction box (1a) using the provided junction box screws (1e) in the hardware package.
Step 4: Determine the hanging height of the fixture by securing the rods (2d) to the canopy (2a) and fixture body (3a) after feeding the fixture wires (LED+ and LED-) through the rods.
Step 5: Make proper electrical connections between LED and DC driver, LED- Negative, LED+ Positive using the quick connector provided. Refer to Illustration 1 and the diagram on the driver for guidance.
Step 6: Make proper electrical connections (black to hot L, white to neutral N, ground to GND) with the wire nuts (1b) provided in the hardware package. Place the driver (4a) in the canopy (2a).
Step 7: Attach the canopy (2a) to the mounting plate (1c) using the canopy screws (2b).
You are now ready to enjoy your fixture.

Contact Information:

For further assistance, please contact:

Please Note:

This Alora LED fixture comes with pre-wired LED module(s)
Unless instructed, Do Not touch any part of the LED module(s) as any unnecessary contact with the module could cause permanent damage
For dimming, an ELV (Electronic Low Voltage) or TRIAC type of dimmer is required
120V input

NOTICE

The important safeguards and instructions outlined in this sheet cannot cover all possible conditions and situations that may occur. It must be understood that caution and certain care factors must be followed. These instructions are provided for your safety and we highly recommend that a licensed, trained electrician install this unit.
This fixture is designed to be mounted on a correctly installed standard round or octagon box OR through a wiring box with a plaster frame. The box must be securely mounted to the structure of the building. The crossbar and hardware supplied should be used, directly mounting the fixture.

Step 1
Remove the fixture from its original package.
Step 2
Separate mounting plate (1c) from canopy (2a) by removing canopy screws (2b).
Step 3
Attach mounting plate (1c) to electrical junction box (1a) using junction box screws provided (1e) in the hardware package.
Step 4
Determine the hanging height of the fixture by securing rods (2d) to the canopy (2a) and fixture body (3a) after feeding fixture wires (LED+ and LED-) through rods.
Step 5
Make proper electrical connections between LED and DC driver, LED- Negative, LED+ Positive using the quick connector provided (See Illustration 1 and refer to the diagram on the driver).
Step 6
Make proper electrical connections (black to hot “L”, white to neutral “N”, ground to “GND”) with wire nuts (1b) provided in the hardware package and place driver (4a) in the canopy (2a).
Step 7
- Attach canopy (2a) to mounting plate (1c) with canopy screws (2b).
- You are now ready to enjoy your fixture.