SDC 528 Montoring Switch Kit Instruction Manual
- June 4, 2024
- SDC
Table of Contents
INSTALLATION INSTRUCTIONS
528
MONTORING SWITCH KIT
SARGENT 20, 60 SERIES
528 Montoring Switch Kit
| ORG | N/C |
|---|---|
| YEL | N/O |
| WHT | COM |
10A @ 125VAC RESISTIVE
Applications
Remote Latch Status Monitoring:
Retracting the latch by depressing the push pad provides an output signal for
local or remote visual and audible annunciation indicating forced entry or
unauthorized egress.
Access Control REX: When connected to the Request-To-Exit input of a
keypad, card, or biometric Access Controller, depressing the push pad and
retracting the latch actuates the Latch Status contact, shunting the control
access control alarm to permit authorized egress and/or releases the magnetic
door lock for uninhibited egress.
Magnetic Lock Release: Where Access Controller with REX input is
unavailable, the N/C contact of the switch is wired in series between the
power supply and fail-safe magnetic lock. Depressing the exit device push pad
retracts the latch, causing the contact to open, thereby releasing the
magnetic lock for uninhibited egress.
Mantrap Logic: Provides N/O and N/C contacts required for 2 or more
communicating doors for Interlock and Mantrap applications.
Any suggestions or comments to this instruction or product are welcome. Please
contact us through our website or email
engineer@sdcsecurity.com
P:\INST INSTRUCTIONS\EGRESS CONTROLS\INST-528 REV D 07-21
SECURITY DOOR CONTROLS •
WWW.SDCSECURITY.COM
[t] 800.413.8783 • 805.494.0622 • E-mail:
service@sdcsecurity.com • 801 Avenida Acaso,
Camarillo, CA 93012 • PO Box 3670, Camarillo, CA 93011
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>