SSV WORKS US-10U Universal Subwoofer User Manual
- June 13, 2024
- SSV WORKS
Table of Contents
SSV WORKS US-10U Universal Subwoofer
Product Information
The SSV Works Universal Subwoofer is a high-quality subwoofer designed for installation in vehicles. It comes with a limited lifetime warranty against defects in material or workmanship. Thesubwoofer is compatible with SSV Works enclosures, electronics, and speakers, which are also covered by warranties.
Parts List:
- Universal Subwoofer
- 7 x 1.25 Screws x8
- Plastic Ribbed Rivet 5mm x6
- 10 x .75 Screw x8
- M6 x 16mm Screws and Washers x12 (T-30 torx)
- B-MB2628 Bracket Amp Cover
- B-MBP2659 Bracket x4
- Vibration Absorption Pads x6
Product Usage Instructions
- Before installing the subwoofer into the enclosure, connect the enclosure’s positive and negative speaker wire into the posts on the subwoofer.
- Using the 8 provided 7 x 1.25 screws, attach the subwoofer into the sub enclosure.
- Depending on the installation location, attach all four mounting brackets on the bottom or back installation position usingthe provided M6x16mm Button Head Torx Screws and M6 Washers to secure the brackets.
- Attach the Amp Cover to the enclosure using four M6x16mm Torx Screws and M6 Washers. Route the sub wiring through the hole cut. Attach all six Vibration Absorption Pads to the back or bottom, depending on the orientation of the enclosure in your vehicle.
- Insert the Plastic Ribbed Rivets into any unused bracket mounting holes.
- Depending on the installation location, attach all four mounting brackets on the bottom or back installation position into the vehicle. Use 8 provided 10 x .75 screws to secure the sub enclosure into the vehicle.
Please note that the product images provided in the manual are for plate installation purposes only, and the actual appearance of the enclosure you purchased may differ from what is shown in the photos.
WARRANTY INFORMATION
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in material or workmanship. All SSV Works Speakers are covered by a limited 1 year warranty against defects in material or workmanship. Labor for replacement of defective components is not covered. Contact SSV Works for further warranty information
TOOLS NEEDED FOR INSTALLATION
- T30 torx
-
2 screw driver
PARTS LIST IMAGES
Sub Enclosure Assembly and Installation
- A. Before installing the Sub into the enclosure, connect the enclosure’s positive and negative speaker wire into the posts on the Sub
- B. Using the (8) 7 x 1.25” Screws, attach the Subwoofer into the Sub Enclosure
- C. Depending on installation location, attach all four mounting brackets on the bottom installation position or the back installation position. Use M6x16mm Button Head Torx Screws and M6 Washers to secure the brackets.
- D. Attach Amp Cover to Enclosure using four M6x16mm Torx Screws and M6 Washers. Route Sub Wiring through hole cut. Attach all six Vibration Absorption Pads to the back or bottom, depending on which position you orient the enclosure into your vehicle.
- E.Insert Olastic Ribbed Rivets into any unused bracket mounting holes.
SUBWOOFER ENCLOSURE HARNESS PLATE INSTALLATION
- Feed the speaker wire through the plate opening
- Secure the plate to the enclosure using the provided hardware
Photos are-for plate installation onty.- The-endosure you purchased may not resemble what is shown in the photos
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>