SSV WORKS US-10 Universal Subwoofer Instructions
- June 3, 2024
- SSV WORKS
Table of Contents
SSV WORKS US-10 Universal Subwoofer Instructions
Please read and understand these instructions completely before installation to avoid possible injury, or damage to the accessory or vehicle.
TOOLS NEEDED FOR INSTALLATION
- T30 torx
-
2 screw driver
PARTS LIST IMAGES
Sub Enclosure Assembly and Installation
A. Before installing the Sub into the enclosure, connect the enclosure’s positive and negative speaker wire into the posts on the Sub.
B. Using the (8) 7 x 1.25” Screws, attach the Subwoofer into the Sub Enclosure.
C. Depending on installation location, attach all four mounting brackets on the bottom installation position or the back installation position. Use M6x16mm Button Head Torx Screws and M6 Washers to secure the brackets.
D. Attach Amp Cover to Enclosure using four M6x16mm Torx Screws and M6 Washers. Route Sub Wiring through hole cut. Attach all six Vibration Absorption Pads to the back or bottom, depending on which position you orient the enclosure into your vehicle.
E.Insert Olastic Ribbed Rivets into any unused bracket mounting holes.
F. Depending on installation location, attach all four mounting brackets on the bottom installation position or the back installation position into the vehicle. Use 10 x .75” Screws to secure the sub enclosure into the vehicle.
WARRANTY INFORMATION
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in material or workmanship. All SSV Works Speakers are covered by a limited 1 year warranty against defects in material or workmanship. Labor for replacement of defective components is not covered. Contact SSV Works for further warranty information.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>