SSV WORKS BR-B65 2021+ Ford Bronco 6.5 Inch Rear Speaker-Pod Add-Ons User Manual

June 9, 2024
SSV WORKS

BR-B65
2021+ Ford Bronco
6.5” Rear Speaker-Pod Add-Ons

BR-B65 2021+ Ford Bronco 6.5 Inch Rear Speaker-Pod Add-Ons

WARRANTY INFORMATION:
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in material or workmanship. All SSV Works Speakers are covered by a limited 1 year warranty against defects in material or workmanship. Labor for replacement of defective components is not covered. Contact SSV Works for further warranty information.

**** Please read and understand these instructions completely before installation to avoid possible injury, or damage to the accessory or vehicle.

TOOLS NEEDED FOR INSTALLATION

  • 1 Phillips Screwdriver

  • T-25 Torx bit
  • T-30 Torx bit

PARTS LIST

  1. BR-B65U Enclosures (1 pair)
  2. T-25 Torx Screws x 4 (Factory Screws)
  3. Phillips Screw x 2
  4. M6 Screws and Washers x 2

PARTS LIST IMAGES

DISASSEMBLY

|
---|---
A. Remove the two screws securing the top mounting bracket to the factory speaker pod. These are hard to remove with a hardtop we recommend using an angle driver.
Note: These two screws will be re-used for the SSV pods.| B. Remove the 3rd screw located at the bottom of the speaker pod bolting the pod to the frame.

INSTALLATION

|
---|---
A. Hold the pod up near its mounting location and connect the
pod to the factory harness.| B. Snap the speaker pod harness cover onto the pod making
sure the harness exits the cover through one of the two reliefs.
|
C. Use the provided Philips screw to secure the cover in place.| D. Loosely assemble the bottom of the pod to the frame of the
vehicle using the provided M6 screw and washer.
|
E. Use the factory screws that were removed in Step A to secure the top of the enclosure.| F. Go back and tighten the bottom M6 screw.

G. Repeat these steps on the driver side.

© 2022 SSV Works, Oxnard, CA 93030
BR-B65 Rev. A 12-02-22
SSV WORKS, 201 N. Rice Ave Unit A, Oxnard, CA 93030
www.SSVworks.com |
Phone:818-991-1778 | Fax: 866-293-6751

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

SSV WORKS User Manuals

Related Manuals