SSV Works 327BR2B65U Vehicle Specific Speaker Pods For Select 2 Door User Guide
- June 13, 2024
- SSV WORKS
Table of Contents
SSV Works 327BR2B65U Vehicle Specific Speaker Pods For Select 2 Door
Product Information
The SSV Works BR-2B65U is a speaker-pod add-on designed for the 2021+ Ford
Bronco 2 Door model. It allows you to enhance the audio experience in your
vehicle by adding rear speakers. The product is manufactured by SSV Works,
located at 201 N. Rice Ave Unit A, Oxnard, CA 93030. For more information,
visit their website at
www.SSVworks.com. You can also contact them by
phone at 818-991-1778 or fax at
866-293-6751.
Tools Needed for Installation
The following tools are required for the installation of the product
- None mentioned in the provided text.
Parts List
| Part | Quantity |
|---|---|
| Passenger Rear Door Pod | 1 |
| Driver Rear Door Pod | 1 |
| Bracket Pack | 1 |
| M6 x Screw | 2 |
| M6 Washer | 2 |
| #1 Phillips Screw | 2 |
WARRANTY INFORMATION
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in material or workmanship. All Kicker Speakers are covered by a limited 1 year warranty against defects in material or workmanship. All Kicker Amplifiers are covered by a limited 2 year warranty against defects in material or workmanship. Labor for replacement of defective components is not covered. Contact SSV Works for further warranty information.
TOOLS NEEDED FOR INSTALLATION
- T25, T30 Torn Driver
- 1 Phillips Screwdriver
PARTS LIST IMAGES
Disassembly
-
A. Remove the screw located at the bottom of the speaker enclosure.
-
B. Removing the two screws securing the bracket to the vehicle. Then remove the two screws securing the bracket to the enclosure.
Note : These 4 factory screws will be re-used for the SSV pods. *This image is of passenger side .|
Installation
-
A. Secure the drivers side bracket to the driver side pod using the factory two screws.
-
B. Hold the pod up near its mounting location and connect the factory harness.
-
C. Snap the speaker pod harness cover onto the pod making sure the harness exits the cover through one of the two reliefs.
-
D. Use the provided Philips screw to secure the cover in place
-
E. Loosely assemble the bottom of the pod to the frame of the vehicle using the provided M6 screw and washer.
-
F. Install the two-factory bolts securing the pod to the vehicle. Note: Image is of passenger side.
-
G. Fully tighten the bottom screw located at the bottom of the pod.
Repeat all steps for the opposite side.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>