Jula 025157 Wall Lamp Installation Guide

Jula 025157 Wall Lamp

Product Information

This product is a wall lamp designed for indoor use. It operates on a voltage of 230V with a frequency of 50Hz. The lamp has a power rating of 60W and uses an E27 socket. It is classified with an IP44 protection rating, making it suitable for use in damp environments. The dimensions of the lamp are approximately B 22.5cm x H 24cm x D 26cm.

Product Usage Instructions

1. Prior to installation, ensure that the power is disconnected.
2. Choose the location where you want to mount the lamp.
3. Drill two holes and insert the mounting plugs into the holes.
4. Fasten the mounting bracket with screws.
5. Connect the wires to the appropriate terminals.
6. Secure the lamp to the mounting bracket using two nut caps.
7. Remove the dome and insert a light source with the maximum recommended wattage specified on the lamp.
8. Screw the dome back on.
9. Connect the power supply.

Maintenance

Caution: Before performing any maintenance, make sure to disconnect the power supply.

1. Disconnect the power supply from the lamp.
2. Clean the lamp with a dry or slightly damp cloth.
3. Wait for the lamp to completely dry before reconnecting the power supply.

NOTE:
Switch off the power supply before maintenance.

1. Disconnect the power supply to the lamp.
2. Wipe the lamp with a dry or slightly damp cloth.
3. Wait until the lamp is completely dry before switching the power supply on again.

NOTE:
Do not use detergent, alcohol, solvent or the equivalent to clean.

Safety Instructions

• Only intended for outdoor use.
• The electrical installation must comply with local regulations. Consult an authorised electrician if in doubt.
• Always follow the electrical specifications on the product labelling.
• Always disconnect the power supply before installation, connection and service.
• Never modify the product, this could result in serious personal injury and/or material damage, and will invalidate the warranty.
• The product must be connected to an earthed power supply on installation.
• Do not use the product without the glass cover.
• The product gets very hot when it is switched on. Do not touch the product with bare hands.
• Switch off and allow the product to cool before replacing the light source.

Electrical Safety:

New installations and extensions should be carried out by an authorized electrician. If you have the necessary experience and knowledge, you can replace power switches, wall sockets, fit plugs, extension cords, and light sockets. Incorrect installation can lead to fatal injuries and the risk of fire.
Jula AB reserves the right to make changes to the product. Jula AB claims copyright on this documentation. It is not allowed to modify or alter this documentation in any way and the manual shall be printed and used as it is in relation to the product. For the latest version of operating instructions, refer to the Jula website.
WWW.JULA.COM
© JULA AB 2023-05-31
JULA AB
BOX 363, 532 24 SKARA, SWEDEN

SYMBOLS

TECHNICAL DATA

DESCRIPTION
For outdoor use with fixture of wrought iron and window of patterned glass. Light source sold separately. Includes assembly screws.

ASSEMBLY

1. Switch off the power supply before installation.

2. Measure out the two drill holes on the underlayer where the lamp is to be installed.

3. Drill the two holes. Tap the plugs in the holes.
   

4. Fit the bracket with the screws.

5. Connect the wires to the terminals. The casing must be connected to earth. Phase conductor (L) – Black or brown Earth conductor ( ) – Yellow/green Neutral conductor (N) – Blue

6. Mount the rest of the lamp on the bracket in the underlayer and fasten with two nut caps.

7. Unscrew the cover and insert a light source with the maximum output specified on the lamp. Screw the cover back on.

8. Connect the power supply.

REPLACING THE LIGHT SOURCE
NOTE:
Switch off and allow the light source to cool before replacing.

1. Disconnect the power supply.
2. Unscrew the cover.
3. Carefully unscrew the cool light source.
4. Carefully insert the new light source.
5. Screw the cover back on before switching on the light source.

References

• Jula – products for home and garden

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>