lionelo Robin Baby Swing User Manual

lionelo Robin Baby Swing User Manual

IMPORTANT! READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

WARNING

• Never leave the child unattended.
• Do not use this product once your child can sit up unaided or weighs more than 9 kg.
• This product is not intended for prolonged periods of sleeping.
• Never use this product on an elevated surface (e.g. a table).
• Always use the restraint system.
• To avoid injury ensure that children are kept away when unfolding and folding this product.
• Do not let children play with this product.
• Do not move or lift this product with the baby inside it.
• This product does not replace a cot or a bed. Should your child need to sleep, then it should be placed in a suitable cot or bed.
• Do not use the product if any components are broken or missing.
• Do not use accessories or replacement parts other than those approved by the manufacturer.
• If you do not use the product, keep the bouncy chair and its power cord out of reach of children.

Assembling

Warning: The product may be installed by adults only!

1. Unfold the frame tubes outwards (Fig. 1).
   

2. Combine the rear and the front base tubes with the tubes of the main frame. The “click” sound indicates that they have properly locked in place (Fig. 2).
   

3. Unfold the seat: unfold the backrest and the seat base (Fig. 3).
   

4. Combine the left and right arm with the frame (Fig. 4).
   

5. To detach the arms from the frame, use a thin tool up to 4 mm (e.g. screwdriver), press the lock and pull out the arms and the tool (2) (3) (Fig. 5).
   

6. Attaching toys to the carousel: Insert the cords (connected to the toys) to the mounts on the carousel leaves (Fig. 6).
   

7. Installing the carousel bar: Slide the end of the carousel bar into the guide until it locks in place (Fig. 7).
   

8. A child sitting in the seat must be secured with the safety harness (Fig. 8). The length of the belts can be adjusted with the clasps (Fig. 9).
   
   

9. The seat can be adjusted to 2 different positions. Press the tilt adjustment buttons (on both sides of the seat, in the middle part) and adjust the seat to lying or sitting position (Fig. 10).
   

10. The carousel can be tilted horizontally so that you can easily seat or take your child out of the swing chair (Fig. 11)
    

11. Folding the base: Press the buttons at the back of the swinging mechanism and fold the rear frame tubes by moving them inwards ( Fig. 12).
    

12. There are two methods of powering the LO-Robin swing chair:
    a. With an included power supply (Fig. 13).
    
    WARNING! Before connecting the AC adapter, the batteries must be removed from the device!
    b. With 4 AA batteries. Unscrew and open the battery cover

13. . Put the batteries into the battery compartment paying attention to the correct polarity (+/-)

14. . Then, place back the battery cover and tighten the screw

15. (Fig. 14).
    

WARNING:

• Do not charge non-rechargeable batteries.
• Rechargeable batteries can only be charged by adults.
• Rechargeable batteries should be taken out of the device’s battery compartment before charging.
• Do not mix used batteries with the new ones.
• Do not mix different kinds of batteries.
• Make sure the batteries are properly installed according to correct polarity (+-).
• Remove exhausted batteries from the device.
• Use the original power supply (included with the product) only.
• Keep batteries and the power supply away from children.
• If you plan not to use the device for extended period of time, please remove the batteries and disconnect it from the power supply.
• Do not plug in the power supply if the batteries are installed in the unit.
• Transformers used with the infant swing are to be regularly examined for damage to the cord, plug, enclosure and other parts, and in the event of such damage, they shall not be used.

Control panel (Fig. 15)

A. swinging speed +
B. bird sound
C. music on/off key
D. cry sensor
E. voice control led indicator
F. swinging speed leds
G. swinging speed –
H. water sound
I. next lullaby/volume
J. carousel on/off key
K. timer

Cleaning and maintenance

• Do not machine wash.
• Do not use bleach to clean the device.
• The fabric parts can only be washed by hand (in up to 30°C).
• Disconnect the device from the power source before cleaning.
• The frame can be cleaned with a damp cloth.

The pictures in this manual are for illustrative purposes only. Therefore, they may differ from the actual product.

Simplified EU/EC declaration of conformity

BrandLine Group Sp. z o. o. hereby declares that the “ROBIN” product complies with the directive: 2014/30/EU – EMC Directive, 2014/35/EU – LVD Directive, 2011/65/EU – RoHS Directive, 2009/48/EC – Toy Directive (Toy set only).
Full content of EU declaration of conformity is available on the following website:

The product complies with requirements of EU directives.
Pursuant to the Directive 2012/19/EU, this product is subject to selective collection. The product must not be disposed of along with domestic waste as it may pose a threat to the environment and human health. The worn-out product must be handed over to the electrics and electronics recycling center

Dear Customer!
In case of any questions or comments on the purchased product, please contact us: help@lionelo.com

Before using the product, please read the included user manual carefully.
Note: The assembly of the product must be performed by an adult. Failure to comply with this provision and the assembly instructions could result in serious injury or even death

Meets the requirements of the standard: EN 16232:2013+A1:2018

Producer:
BrandLine Group Sp. z o. o.
ul. A. Kręglewskiego 1, 61-248 Poznań, Poland

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>