SUNRICHER RF+Bluetooth CCT Wall Mounted Remote User Guide
- June 4, 2024
- SUNRICHER
Table of Contents
SUNRICHER RF+Bluetooth CCT Wall Mounted Remote
Important: Read All Instructions Prior to Installation
Function introduction
Product Data
| Output | RF+Bluetooth signal |
|---|---|
| Operation Frequency | 2.4GHz |
| Power Supply | 3V(1xCR2450 battery) |
| Operating temperature | 0-40°C |
| Relative humidity | 8% to 80% |
| Dimensions | 80x80x13.6mm |
- RF+Bluetooth CCT remote
- Control 1 zone of RF+Bluetooth receiver
- Enables to save and recall 2 scenes for each zone
- Easy & quick pairing to the RF+Bluetooth receivers by simply pushing the buttons
- Mesh network for further control distance, receivers can transmit signal to each other
- Each remote can control numerous receivers
- Each receiver can be paired to max. 8 remote controls
- The controlled receiver status can be quickly synchronized to the smart APP
- Transmission range between every two neighbor devices up to 30m
- Bluetooth low power consumption technology, long battery life
- Waterproof grade: IP20
Safety & Warnings
- This device contains a button lithium battery that shall be stored and disposed properly.
- DO NOT expose the device to moisture.
- Do not ingest battery, Chemical Burn Hazard
- This product contains a coin / button cell battery. If the coin / button cell battery is swallowed, it can cause severe internal burns in just 2 hours and can lead to death
- Keep new and used batteries away from children.
- If the battery compartment does not close securely, stop using the product and keep it away from children.
- If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention
Pair with RF+Bluetooth receiver
- Step 1 :Do wiring the RF+Bluetooth receiver according to wiring diagram(please refer to the instruction of RF+Bluetooth receiver that you would like to pair with.
- Step 2 :Click the Prog. Key or Reset button on RF+Bluetooth receiver (or reset power of the receiver 3 times continuously if the button is not accessible) to set it into pairing to RF remote status
- Step 3 :Click any button of the remote(e.g. button receiver flicker means the receiver is paired with the remote successfully. Note: one receiver can be paired with max 8 remote controls.
Installation
Remove battery insulator
Install the controller to wall(2 methods)
- Method 1 :Stick 3M glue on the back of the bracket and then stick the bracket to the wall
- Method 2 :Screw the bracket to the wall
The key part of this controller is a universal, standard size design switch element that can be integrated in numerous frames by different manufactures as below list:
| BERKER | S1, B1, B3, B7 glass |
|---|---|
| GIRA | Standard55, E2, Event, Esprit |
| JUNG | A500, Aplus |
| MERTEN | M-smart, M-Arc, M-Plan |
CAUTION
Risk of explosion if the battery is replaced by an incorrect type
- replacement of a battery with an incorrect type that can defeat a safeguard (for example, in the case of some lithium battery types);
- disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas;
- a battery subjected to the extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>