i3 INTERNATIONAL B88T Angle Mount Camera Bracket for Ax88 User Manual

**i3 INTERNATIONAL B88T Angle Mount Camera Bracket for Ax88 User Manual

**

The B88T is an tilt angle mount back box for cable management and can be used for surface or horizontal wall mounting of i3’s Ax88 fisheye camera model.

• Tilt bracket for Ax88 Fisheye camera for best Panoramic view, ideal for wall mounting
• Back box for IP camera wire management.
• Suitable for outdoor and indoor installations.
• Six (6) pre-drilled hole dimples for surface mounting.

PACKAGE CONTENTS

In addition to this manual and B88T back box, the packing box includes:

1. Round head screw, machine type x3

2. Round head screw, tapping type with O-ring x4

3. Plastic anchor x4

4. Surface Mount template x1
   

DIMENSIONS

 INSTALLATION NOTES

• Ensure that the mounting surface and mounting hardware is suitable for the chosen installation method.
• To maintain IP67 waterproof rating, always use the waterproof RJ45 connector supplied with the camera.
• Always add sealant to all threads in outdoor installations.
• Use a network cable 5mm or more in diameter to create a good seal in RP1.
• Tighten the provided tapping screws to fully compress the ‘O’ ring.

SURFACE INSTALLATION

Use the security Torx bit or screwdriver (not provided) to loosen four screws securing the dome bubble to the Ax88 camera. Set the dome bubble aside.

1. B88T comes with six 90% pre-drilled hole dimples. Depending on the type of installation and mounting surface, complete drilling 2-3 holes.
2. Attach the mounting template (4) to the mounting surface.
3. Drill holes in the mounting surface, as marked on the template, to match the pre-drilled B88T holes.
4. Insert anchors (3) into the holes.
5. Drill the conduit hole for the camera cable, as marked on the template.
6. Secure the B88T back box to the mounting surface using the tapping screws with the O-ring (2). Tighten to fully compress the ‘O’ ring.
7. Pull the camera’s cable into the B88T back box.
8. Use the round head machine screws (1) to secure the camera base to the back box.
9. Re-attach the dome bubble.
   Note: DO NOT MOVE OR ROTATE THE FISHEYE CAMERA LENS

Figure C. Attaching B88T to the mounting surface.

• Attach the mounting template to the mounting surface.
• Drill holes in the mounting surface to match the holes in B88T.
• Insert plastic anchors into the holes in the mounting surface.
• Drill the conduit hole for the camera cable.
• Secure B88T to the mounting surface using the tapping screws with the O-ring. Tighten to fully compress the ‘O’ ring.

Figure D. Attaching Ax88 to B88T

• Pull the camera’s cable into the B88T.
• Secure Ax88T to B88T using the round head machine screws

Figure E. Attaching Ax88 dome bubble

• Re-attach the dome bubble.
• IMPORTANT: DO NOT MOVE OR ROTATE THE FISHEYE CAMERA LENS

**Figure F. Complete Installation.

**

can this QR code or visit ftp.i3international.com to view i3 product manuals.

Contact our Technical Support team at: 1.877.877.7241 or support@i3international.com if you have any questions or concerns regarding camera installation or if you require software services or support.

QR Code for Complete User Manual and ACT

References

• i3 International FTP Login Page

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>