WIRCRACING GT4E-2 New Generation RC Car Instruction Manual
- June 17, 2024
- WIRCRACING
Table of Contents
GT4E-2 New Generation RC Car
Instruction Manual
INTRODUCTION
GT4E is a new generation high quality 1/8 scale GT electric car.
GT4E is supplied in a box,you can download the Instruction manual from
www.wircracing.com
Its use is intended for more than 16 years old persons with experience on rc
model car field.
Children and all the persons without this requirement MUST have direct
supervision of a knowledgeable adult responsible.
SAFETY PRECAUTIONS
Instruction Manual MUST be read and fully understood before to start building
and operating functions.
Always keep Instruction Manual in safety place, ready to be consulted for any
reference you need.
Use only original WIRC spare parts.
GENERAL INFORMATION
Assemble the kit only away from the reach of children.
Follow the building and operating instructions using the utmost care.
Don’t put any part of your body inside rotating and moving elements as this
may cause damage or serious injury.
Check and clean the model before putting it away.
Don’t use your model car in public places or in roads and areas where it could
generate conflict with person or vehicular traffic.
The model car is controlled by radio: you MUST put great care to avoid loss of
radio control always keeping a safety margin all around your model in order to
prevent any collision.
Operating frequency: check and be sure it is clear and not shared with anybody
at same time; it could cause loss of control of the RC model.
Always turn on your transmitter before you turn on the receiver in the car and
always turn off the receiver before you turn off your transmitter.
Keep the wheels of the model off the ground when checking the operation of the
radio equipment. Disconnect the battery pack before storing your model.
WARRANTY
WIRC guarantees this model kit to be free from defects in both material and
workmanship within 30 days of purchase.
The total monetary value under warranty will in no case exceed the cost of the
original kit purchased.
This warranty doesn’t cover any compnents damaged by use or modification or as
result of wear. Part or parts missing from this kit must be reported within 30
days of purchase.
No part or parts will be sent under warranty without proof of purchase.
If you find a defective or missing part, contact the local distributor.
Customer service and support will be provided through local hobby store.
No warranties are expressed or implied that cover damage caused by what is
considered normal use or cover or imply how long any model cars’ components or
electric components will last before requiring replacement.
Due to the high performance level of this model car you will need to
periodically maintain and replace consumable components; any and all warranty
coverage will not cover replacement of any part or component damaged by
neglect, abuse or improper or unreasonable use.
This includes but is not limited to damage from crashing, excessive moistur,
improper use or no maintenance or user modifications which compromise the
integrity of components.
Warranty will not cover compnents that are considered consumable on RC model
car.
WIRC doesn’t pay nor refund on any component sent from WIRC or its distributor
for warranty.
WIRC reserves the right to make final determination of the warranty status of
any component or part Use only original WIRC spare parts.
CUSTOMER SUPPORT
Please don’t hesitate to contact WIRC support at
info@wircracing.com for any problem or question.
Also kindly visit our website www.wircracing.com
to find last updates, set-up, option parts and other informations.
World racing car s.r.l.
Via A. Volta 2 Bis
36040 Brendola (VI)
ITALY
Phone: 0039 0444 1792263
E-mail: sales@wircracing.com
Website: www.wircracing.com
TECHNICAL INFORMATION
- WHEELS LOCK:Lightweight 17 mm 7075 T6 Nut
- CHASSIS:4.0 mm Swiss 7075 T6 aluminium
- RADIO PLATE:Composite Material
- DRIVETRAIN TYPE:Spring steel CVD Driveshfts
- FRONT DIFFERENTIAL:Differential Gear
- REAR DIFFERENTIAL:Differential Gear
- SUSPENSION:Pivot ball suspension
- RIDE HEIGHT:Adjustable Front & Rear
- CAMBER:Adjustable Front & Rear
- CASTER:Adjustable Front
- TOE:Adjustable Front & Rear
- ROLLCENTER:Adjustable Front & Rear
- ACKERMANN:Adjustable Front
- ANTI-ROLL BARS:Adjustable Front & Rear
TECHNICAL DATA
| – WIDTH | 310 mm |
|---|---|
| – WHEEL BASE | adjustable 315-320 mm |
| – WEIGHT READY TO RUN | 3500g |
ADDITIONAL ITEMS NEEDED FOR COMPLETION (REQUIRED BUT NOT INCLUDED IN THE
KIT)
TOOLS REQUIRED
THESE TOOLS ARE NOT INCLUDED IN THE KIT BUT ARE REQUIRED FOR PROPER
ASSEMBLY 
NOTICE:
THE FOLLOWING ITEMS ARE NEEDED FOR COMPLETION OF THE GT4E; THEY ARE NOT
INCLUDED IN THIS KIT (UNLESS NOTED) AND SHOULD BE OBTEINED FROM YOUR LOCAL
HOBBY SHOP.
BE SURE TO READ THE INSTRUCTION COMPLETELY PRIOR TO ASSEMBLY
Front Diff. Gear
Rear Diff. Gear
Rear Transmission
Front Transmission
Front Suspension
Front Upright
Rear
Suspension
Front & Rear Assembly **
**
Batteries supports
Front/Rear
SHOCK FILLING
Fully extend the piston rod so the piston is at the bottom of the shock body.
Hold the shock upright and fill the shock body with shock oil as in the
picture.
Let the oil settle and allow air bubbles to rise to the top.
Slowly move the piston up and down until no more air bubbles appear.
Add shock oil as necessary. Pull the piston rod most of the way out of the
shock bod.
Let the shock rest for 5 minutes to allow the air bubbles to
scape.
Rear Shock
Front Bumper
Final Assembly
Driver:……………..
Date:…………………………..
Track:…………….
Event:…………………
Front Suspension:|
---|---
Ride Height:
Camber:
Toe:
Anti-Roll Bar|
Size:
Gap:
Ackerman|
Drive Shaft:|
Chassie Brace:
Hex:
Rear Suspension:|
---|---
Ride Height:
Camber:
Toe:
Anti-Roll Bar|
Size:
Gap:
Drive Shaft:|
Chassie Brace:
Hex:
Shocks:| Front| Rear|
---|---|---|---
Piston:| |
Membrane:| |
Oil:| |
Spring:| |
Rebound:| |
Free Lenght:| |
Electronics :|
---|---
Radio:|
Servo:|
Epa:| Throttle: % Brake: %
Expo:| Throttle: % Brake: %
Esc:|
Motor:|
Battery:|
Differentials:| Front| Rear
---|---|---
Case Mat.:| |
Oil:| |
Crown Gear:| |
Body, Wing:|
---|---
Body:|
Wing:|
Manifold:|
Wing Height:|
Gap to tower:|
Tires:| Front| Rear
---|---|---
Brand:| |
Pattern:| |
Insert:| |
Whells:| |
Compound:| |
Note: Tot. Car Weight:
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>