i3 INTERNATIONAL B77 Back Box Mounting Base User Manual
- June 4, 2024
- i3 INTERNATIONAL
Table of Contents
i3 INTERNATIONAL B77 Back Box Mounting Base
Back Box Mounting Base
The B77 is an extension back box for cable management and can be used for surface, pendant or horizontal wall mounting of i3’s M77 camera series.
- Back box for IP camera wire management.
- Suitable for outdoor and indoor installations.
- Four (4) pre-drilled mounting holes for surface mounting (covered with black rubber plugs).
- Optional use with Pendant Mount EMT Pipe 3/4” or DB60 Horizontal Wallmount bracket.
PACKAGE CONTENTS
In addition to this manual and B77 back box, the packing box includes:
- Round head screw, machine type x4
- Round head screw, tapping type, with ‘O’ ring x4
- Plastic anchor x4
- Surface Mount template x1
- 3/4 coupler x1 with O-ring. Attach to the conduit opening.
DIMENSIONS
- 1/2” top conduit hole. Attach the
- 3/4” coupler provided. (Figure B)
INSTALLATION NOTES
- In pendant and horizontal wall-mount installations, screw the 3/4” coupler into the top conduit hole. Tighten to fully compress the ‘O’-ring on the coupler. (Figure B)
- In outdoor installations, add silicone to the 3/4” coupler threads, as well as DB60 Goose neck bracket or EMT pipe threads (if using).
- Ensure that the mounting surface and mounting hardware is suitable for the chosen installation method. To maintain IP67 waterproof rating, always use the waterproof RJ45 connector supplied with the camera.
- Use sealant on all threads during installation. If using the side conduit hole, move the metal plug from the side conduit to the top conduit hold.
INSTALLATION
Use the hex screwdriver or bit (not provided) to loosen four screws securing
the dome bubble to M77 camera. Set the dome bubble aside.
Surface Installation
- Attach the mounting template (4) to the mounting surface.
- B77 comes with four pre-drilled holes. Depending on the type of installation and mounting surface, complete drilling 2-3 holes, as marked on the template.
- Insert anchors (3) into the holes.
- Drill the conduit hole for the camera cable, as marked on the template; pull the camera cable into the back box.
- Remove the rubber plugs from the holes on the back box matching the ones drilled on the mounting surface. Secure the B77 back box to mounting surface using the tapping type screws (2). Tighten the screws to fully compress the ring.
- Use machine type screws (1) to attach M77 camera to the B77 back box.
- Re-attach the dome bubble.
DB60 / Pendant Installation (Follow Figure C)
- Pull the camera’s cable into the DB60 or the 3/4 EMT pipe.
- Attach B77 to the DB60 or to the 3/4” EMT pipe (using a conduit fitting). Add sealant on all threads as shown in Figures B and C.
- Use machine type screws (1) to attach M77 camera to the B77 back box.
Scan this QR code or visit ftp.i3international.com to view i3 product manuals.
Contact our Technical Support team at: 1.877.877.7241 or
support@i3international.com if you have
any questions or concerns regarding camera installation or if you require
software services or support.
References
Read User Manual Online (PDF format)
Loading......