i3 INTERNATIONAL B79 Back Box Mounting Base User Manual
- June 4, 2024
- i3 INTERNATIONAL
Table of Contents
User Manual
B79
Back Box Mounting Base
The B79 is an extension back box for cable management and can be used for surface, pendant or horizontal wall mounting of i3’s M79 camera series.
- Back box for IP camera wire management.
- Suitable for outdoor and indoor installations.
- Six (6) pre-drilled hole dimples for surface mounting. Optional use with Pendant Mount EMT Pipe 3/4” or DB60 Horizontal Wallmount bracket.
PACKAGE CONTENTS
In addition to this manual and B79 back box, the packing box includes:
1. Round head screw, machine type x4|
---|---
2. Round head screw, tapping type with O-ring x3|
3. Plastic anchor x3|
4. Surface Mount template x1|
DIMENSIONS
INSTALLATION NOTES
- In outdoor installations, remove RP1, add silicone to the DB60 Goose neck bracket or EMT pipe threads (if using) and tighten the provided tapping screws to fully compress the ‘O’ ring.
- Ensure that the mounting surface and mounting hardware is suitable for the chosen installation method.
- To maintain IP67 waterproof rating, always use the waterproof RJ45 connector (Figure C).
- Use sealant on all threads during installation.
- Use a network cable 5mm or more in diameter to create a good seal in RP1 (if using).
INSTALLATION
Use the notch to lift the M79 magnetic ring cover. Set aside.
Surface Installation
- B79 comes with six 90% pre-drilled hole dimples. Depending on the type of installation and mounting surface, complete drilling 2-3 holes.
- Attach the mounting template (4) to the mounting surface.
- Drill holes, as marked on the template, to match the holes pre-drilled on the back box in Step 1.
- Insert anchors (3) into the holes.
- Drill the conduit hole for the camera cable, as marked on the template; pull the camera’s cable into the B79 back box.
- Secure the B79 back box to the mounting surface using the screws with the O-ring (2). Tighten to fully compress the ‘O’ ring.
- Use machine-type screws (1) to attach the M79 camera to the B79 back box.
- Re-attach magnetic cover ring.
DB60 / Pendant Installation (Follow Figure B)
Note: Do not drill any holes in B79.
-
Pull the camera’s cable into the DB60 or the 3/4 EMT pipe.
-
Attach B79 to the DB60 or to the 3/4” EMT pipe (using a conduit fitting).
Add sealant as shown in Figure B i3-TRNG-CAMS-B79.indd -
Use machine-type screws (1) to attach the M79 camera to the B79 back box.
Re-attach magnetic cover ring dome bubble.
WATERPROOF RJ45 CONNECTOR
Scan this QR code or visit
ftp.i3international.com to view i3 product
manuals.
Contact our Technical Support team at: 1.877.877.7241 or
support@i3international.com if you have
any questions or concerns regarding camera installation or if you require
software services or support.
http://ftp.i3international.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>