BEGA 51015.1 Ceiling Luminaire for Indoor Use Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
BEGA 51015.1 Ceiling Luminaire for Indoor Use Instruction Manual
Instructions for use
Application
Ceiling luminaire · indoor luminaire impact resistant synthetic diffuser and
metal housing for non-glare light deflected downwards.
Product description
- Ceiling luminaire »STUDIO LINE«
- Aluminium luminaire housing, finish Colour velvet black inside hue white
- Metal luminaire mounting plate, finish Colour velvet black
- Impact resistant synthetic diffuser, white, with bayonet closure 2 mounting holes ø 5.5mm
- Distance apart 180mm 2 cable entries for through-wiring for mains cable up to ø 10.5 mm max. 3 × 1.5@
- Connection terminal 2.5@
- Earth conductor connection
- Lampholder E 27
- Safety class I
- Impact strength IK10
- Protection against mechanical impacts < 20 joule r – Safety mark c – Conformity mark
- Weight: 1.6 kg
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician. The manufacturer accepts no liability for damage
caused by improper use or installation. If subsequent modifications are made
to the luminaire, the person responsible for these modifications shall be
considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547. To achieve an additional
protection against e.g. transients, etc. we recommend separate overvoltage
protection components. You can find them on our website at
www.bega.com.
Lamp
Luminaire with lampholder E 27 Lamp output max. 40 W This product contains
light source of energy efficiency class E
51 015.1K3
inclusive BEGA LED lamp 13 592 dimmable
LED: 12 W 1400 lm
Colour temperature: 3000 K
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Installation
Before installing onto the ceiling the luminaire mounting plate must be
inserted into the luminaire housing.
Thereby pass the mains supply cable through the grommet into luminaire
mounting plate. Fix monting plate inside the luminaire housing with enclosed
or any other suitable fixing material on to the mounting surface. Dismantle
the mains supply cable approx. 60 mm. Pull silicone sleeves over the wires and
make earth and electrical connection to the terminals. Insert lamp.
in order to securely install the synthetic cover in the fitting, the top opening of the synthetic cover must be inserted into the luminaire housing at an angle. Make sure that at least one of the recesses in the edge of the synthetic cover matches the position of one of the lugs on the fitting – see drawing.
IMPORTANT:
Turn the synthetic cover upwards into the fitting as far as it will go. Now
secure the synthetic cover in the fitting by turning it clockwise.
Only then is the synthetic cover held securely in place and resistant to
vibration.
The synthetic cover is removed by turning it anti-clockwise as far as it will go while simultaneously pushing the synthetic cover up against the luminaire fitting.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Relamping
Disconnect from main supply. Unscrew synthetic diffuser from luminaire housing
by turning it counter-clockwise. Change the lamp. Screw in synthetic diffuser
by turning it clockwise. A damaged synthetic diffuser must be replaced.
Spares
LED lamp: 13 592
Synthetic cover : 15 000 424
Lampholder: 63 000 585
Shield: 71 001 759 B10
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>