BEGA 12210.3 LED Wall Luminaire Instruction Manual
- June 13, 2024
- BEGA
Table of Contents
BEGA 12210.3 LED Wall Luminaire Instruction Manual
Application
Enclosed and free-radiating wall luminaire made of hand-blown opal glass, with metal housing, for all lighting tasks in interior applications.
Product description
Metal luminaire housing, finish Chrome
Hand-blown opal glass
Metal shield, chrome finish
2 mounting holes ø 4.5mm
Distance apart 250mm
2 cable entries for through-wiring for connection cable up to ø 10,5 mm max. 5
x 1.5@
Connection terminal 2.5@
Earth conductor connection
2-pole connecting terminal for digital control
BEGA Ultimate Driver®
LED power supply unit
220-240 V x 0/50-60 Hz
DC 176-276 V
DALI-controllable
Basic insulation is provided between the mains and control cables
BEGA Thermal Control®
Temporary thermal regulation to protect
temperature-sensitive components without
switching off the luminaire
Safety class I
r – Safety mark
c – Conformity mark
Weight: 1.1 kg
This product contains light sources of energy efficiency class(es) D
Safety
The installation and operation of this luminaire are subject to national safety regulations. Installation and commissioning may only be carried out by a qualified electrician. The manufacturer accepts no liability for damage caused by improper use or installation. If subsequent modifications are made to the luminaire, the person responsible for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against overvoltage in accordance with DIN EN 61547. To achieve an additional protection against e. g. transients, etc. we recommend separate overvoltage protection components. You can find them on our website at www.bega.com.
Lamp
Module connected wattage 16.4 W
Luminaire connected wattage 19 W
Rated temperature ta=25 °C
Ambient temperature ta max=45 °C
12 210.3K3
Module designation LED-0594/930
Colour temperature 3000 K
Colour rendering index CRI > 90
Module luminous flux 2415 lm
Luminaire luminous flux 1335 lm
Luminaire luminous efficiency 70,3 lm/W
Installation
LED are high-quality electronic components! Please avoid touching the light output opening of the LED directly during installation or revamping. Lead the mains supply cable through the cable entry into the luminaire housing. Fix the mounting plate with enclosed or any other suitable fixing material onto the mounting surface. Be sure to use the gasket rings supplied. Establish earth conductor connection and make the electrical connection to the terminals. For digital control please use the connecting terminal DA, DA. In case this terminal is not used the luminaire will be operated at full light output. Insert the glass into luminaire housing and fix it by screwing the shield hand-tight clockwise onto the glass. Remove the protective film from the shield. NOTE: If adhesive residue from the protective film remains on the edge of the shield, it can be removed using commercially available lighter fluid.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt. Defective glass must be replaced.
Replacement of the LED module
The designation of the LED module is noted on a label in the luminaire. The light colour and light output of BEGA replacement modules correspond to those of the modules originally fitted. The module can be replaced by qualified persons using standard tools. Disconnect the system and open the luminaire. Please follow the installation instructions for the LED module. Defective glass must be replaced. Close the luminaire.
Spares
Spare glass 11 003 167 .1
LED power supply unit DEV-0312/700
LED module 3000 K LED-0594/930
Shield 72 001 008M
BEGA Gantenbrink-Leuchten KG · Postfach 3160 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>