EVERTONE 129-1948 Prosage Thermo Copper Massage Gun User Manual
- June 5, 2024
- Evertone
Table of Contents
- EVERTONE 129-1948 Prosage Thermo Copper Massage Gun
- Safety Instruction
- Product Features
- Charge the device
- Operating Instructions
- Maintenance and Caring
- Technical Specification
- Warranty
- Disclaimer
- To Purchase
- Customer Service:
- Join the Club & Save 20% Off Every Order
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
EVERTONE 129-1948 Prosage Thermo Copper Massage Gun
Thank you for your purchase of Prosage Thermo. Please read the user manual
before use.
The Prosage Thermo is the only professional Hot and Cold massage, percussive
therapy gun with warm up technology for everyday pains.
- Prepares your muscles for the deep tissue massage
- Helps prevent future injuries
- Helps Improve range of motion
- Helps activate your muscles to perform at peak levels.
Safety Instruction
- For adult use only.
- Use only on a dry surface of the body by lightly pressing and moving across the body for approximately 60 seconds per region.
- Use the Prosage Thermo only on the body’s soft muscle tissue as desired without producing pain or discomfort. Do not use on the head or any hard, bony area of the body.
- Use only the attachments provided.
- Bruising can occur regardless of control setting or pressure applied. Check treated areas frequently and immediately stop at first sign of pain or discomfort.
- Keep fingers, hair, or any other body part away from the shaft and backside of the applicator as pinching may occur.
- Do not place any objects into the ventilation holes of the Prosage Thermo.
- Do not immerse in water or allow water to enter the ventilation holes of the Prosage Thermo.
- Do not drop or misuse the Prosage Thermo.
- Only recharge with supplied 9VDC Prosage Thermo Charger
- Never leave the Prosage Thermo operating or charging unattended.
Product Features
This Set Includes:
- 1 x Massager Device
- 8 x Interchangeable Attachments
- 1 x Charging Base/ Holding Stand
- 1 x DC Adaptor
Attachments:
- Silicone Ball Head
- Silicone Cone Head
- Silicone Accupressure Head
- Heat Attachment
- Cold Gel Attachment
- Silicone Fork Head
- Silicone Fingers Head
- Scalp Massage Head
MicrocurrentTek pads
Extension handle
Charge the device
- Remove the adaptor cover at the bottom of the charging base. (See Fig. 1)
- Place the 9VDC adaptor into compartment (See. Fig 2) and secure the cover.
- Then the adaptor jack will be fixed firmly on the charging base (See Fig. 3)
- Plug the AC adaptor cable into a wall outlet and then place the device on the charging base (See Fig. 4)
- The charging indicator light on the device (above the control button) will blink Red. Upon full charge the indicator light will turn Blue. (*Please Note: The device cannot be used whilst charging.)
- Charge for 3-4 Hours for full charge. This will charge the device for use of 70 mins.
Operating Instructions
-
Select the appropriate interchangeable attachment for your needs, then screw the selected attachment (clockwise) the into the massager head.
- Please note: The Cold Gel attachment needs to be placed in the freezer for 1-2 hours before use.
-
Long press the motor button on the control board for 3 seconds to start the motor;D ef ault motor rotation (1 ), blue light panel on;Press the motor button on the main control board again to make the motor faster (in second gear);Press again, the motor becomes faster (in third gear);Press the cycle again to (1) in turn;Press the button for another 3 seconds to stop the motor and put out the blue light.
The blue light on the shaft will indicate the device is ON and will auto start at LO level. Press the power button again to select MID level, and once more for HI level.- Please note: The Theralite function is not intended for use with the Hot and Cold attachment heads. The Theralite will be blocked during use with the Hot & Cold attachments.
-
Keep the heating switch on the control panel for 3 seconds, the PTC heating plate is powered on and the red plate is on, then keep the heating switch on for 3 seconds and the red light is off.
-
EMS functions: massage, hammering, kneading, firming, acupuncture, intensity 1-S;Specific operation: long button on the control panel open EMS function mode button 3 seconds, the def ault massage, press the mode button again to switch to the beat, to press the mode button again to switch to the kneading, press the mode button again, switching to compact file to press the mode button again to switch to the acupuncture and moxibustion, massage, press the mode button once to switch in circulation, longer toggle mode button on the control panel for 3 seconds to shut down the EMS functions;When each gear is on, the mode intensity is 1. The 11 +11 and 11 11 buttons on the control panel can be pressed to adjust the intensity.
-
Charging status: charging with a blue light on and off to prompt;Full of blue lights always on;AII functions of pressing the switch in charging state do not work;
-
Blocking protection tip: When the red light flashes continuously for 5 times in a row and stops, the motor button can be started normally. • Low voltage alarm, the red light flashes for 5 times in a row, and all switches cannot work when pressed;
-
Massage the desired body part at the desired speed, applying pressure as needed.
-
A blocking protection is set up, when you continue to press your body with device too hard, the device will blink and automatically shuts off to protect internal electronic components from burning Press START to resume operating the device.
-
Use the silicone strap to better assist your grip and angle whilst in use.
-
The massager is preset with a 10 minute AUTO-OFF timer.
-
When the power/intensity begins to lessen (slow down), please place the device on the charging base to recharge.
Maintenance and Caring
- For Maintenance use a slightly damp towel to clean the device and dry with a soft dry cloth
- Do not use the product for over 30 minutes continuously. Doing so may activate the over heating protection switch and stop operation automatically. If this happens, please wait at least 30 minutes in order to let the device cool down before re using again.
Technical Specification
Battery Capacity | 2200 mAH |
---|---|
Power by | AC adaptor input 100-240V/50-60Hz |
Output Voltage | 9V DC 1A |
Max. Current | 6000 mA |
Power Consumption | 40W |
1st mode Speed | 3100 Rpm 51 Hz |
2nd mode Speed | 3600 Rpm 60 Hz |
3rd mode Speed | 4200 Rpm 70 Hz |
Charging Time | 3-4 hours |
Work for when fully charged | 70 mins |
Auto Timer | 10 minutes |
Weight only the massager | 700 gms / 1.54 lbs |
weight – full set | 1582 gms / 3.48 lbs |
Overall size of massager | 23.7 X 8.5 X 14.4 cm |
Warranty
- Damage caused by failure to follow the instructions, human factors, force majeure, etc. is not covered by warranty.
- Maintenance cost will be charged for product out of warranty.
- You can register for your free warranty on www.EVERTONEPROSAGE.com.
**** In order for this free warranty to be valid and to allow us to meet your requirements, please register your purchase(s) with evertoneprosage.com. Please visit www.evertoneprosage.com and complete all details. You must have a valid email address to register. Please retain your original receipt to validate your purchase.
Disclaimer
In the process of the preparation of this manual, we have sought to make the
content correct and complete. However, there is no guarantee that there are no
errors or omissions in the manual.
We reserve the right to change specifications of the products mentioned in
this manual at any time without prior declaration. No part of this manual
shall be reproduced, transmitted, transcribed or stored in a searchable system
or translated into any other languages without the written authorization of
our company. The company is not responsible for the loss caused by non-
standard or wrong operation.
The Prosage Thermo System does not guarantee specific results for individuals
who use Prosage Thermo due to many factors that can influence health & weight
loss. Prosage Thermo is not intended to diagnose, treat, cure or prevent any
disease, illness or medical condition.
This is not a weight loss system. Individual results may vary. We make no
warranties or guarantees. No individual results should be considered typical
or guaranteed. The results of Prosage Thermo may be temporary. This product
has not been evaluated by the FDA. Patent Pending Applied.
To Purchase
To replace or repurchase attachments, or to purchase new attachments and ad- ans, please visit us at www.evertoneprosage.com
Customer Service:
Phone: 516-653-0666
Email: CustomerService@Evertoneusa.com
www.evertoneprosage.com
Register now for preferred Savings Club and save 20% on every order www.igia.com
Join the Club & Save 20% Off Every Order
- As an IGIA ™ Savings Club Member, You will recieve 20% OFF any item advertised on our website.
- “No Worry” Membership Renewal: A one time fee of $29.99 for a years worth of savings
- Save BIG on every purchase you make, potentially saving you hundreds of dollars
- We Guarantee our Club will pay for itself, time after time.
Join now & start saving today!
Visit us at www.lGIA.com
CONTACT US
Call us 1(516) 653-0666 Email: Sales.lgiany@gmail.com
Register for your FREE warranty
Thank you for shopping with us! We are confident that you will be very
satisfied with your purchase. To protect your purchase and register for your
warranty, please visit us at
www.lGIA.com. Located at the top right hand of the
website you will find an icon listed “Warranty Registration”; This is where
you will fill in the necessary fields to register and receive your warranty.
We appreciate your support and look forward to your future savings! If you
have any questions, please don’t hesitate to contact us at:
Sales.lgiaNY@Gmail.com
Visit us at www.lGIA.com