BEGA 31 226 Wall Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
BEGA 31 226 Wall Luminaire Instruction Manual
BEGA
Wandleuchte
Wall luminaire
Applique
Instructions for use
Application
Wall luminaire made of copper and hand-blown crystal bubble glass.
An annular shield which is positioned in the centre of the incandescent lamp
prevents
glare from the luminaire without affecting the brilliance of the crystal
bubble glass.
For many lighting tasks in or on buildings
Product description
Luminaire made of copper
Crystal bubble glass with screw neck
Silicone gasket
Wall mounting with a mounting plate made of stainless steel, Steel grade
number 1.4301
Mounting plate with 2 fixing
holes ø 4.5mm · 52mm spacing
-
cable entry for mains supply cable up to ø 10,5mm
Connecting terminals 2.5@ Earth conductor connection
Lampholder E 27
Safety class I
Protection class IP 44
Protected against granular foreign bodies -
1 mm and splash water
Impact strength IK06 Protection against mechanical impacts < 1 joule r – Safety mark c – Conformity mark
Weight: 3.7 kg
Lamps
-
Luminaire with screw base E 27
Lamp output max. 2 × 60 W
This product contains light sources of energy efficiency classes E, F
Supplied lamp -
× BEGA LED lamp 13583 LED Retrofit 7 W · 805 lm · 3000 K Luminaire efficiency: 41%
Additional BEGA LED lamps are available for this luminaire: 13 585 LED 7 W · 805 lm · 3000 K dimmable
Detailed technical and lighting data for the lamps can be found in the data sheets on our website.
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer
Installation
Please use the protective gloves provided for the installation to prevent
fingerprints on the luminaire.
Screw glass out of the luminaire base.
Undo screw of the wall box.
Remove mounting plate from wall box.
Lead the mains supply cable through the cable entry of the mounting plate.
Note position of application of the mounting plate “arrow down”.
Fix the mounting plate with enclosed or any other suitable fixing material
onto the mounting surface.
It is absolutely essential to use the enclosed gaskets.
Make earth conductor connection and make electrical connection.
Note position of application of luminaire “arrow down”.
Make earth conductor connection between luminaire and mounting plate. Place
the luminaire housing on the mounting plate, adjust and tighten screw.
The luminaire can be operated either with an incandescent lamp or with a
compact fluorescent lamp – lampholder E 27. Insert lamp. Slide glass with
gasket over the lamp and screw into the luminaire.
Make sure that the gasket is positioned correctly
Relamping · Maintenance
Disconnect the electrical installation.
Open the luminaire and clean.
Use only solvent-free cleaning agents. Change the lamp.
Check the gasket and replace, if necessary. Close the luminaire.
For cleaning, do not use high pressure cleaners.
Copper
The luminaire parts made of solid copper are delivered with the metal’s
natural surface colour.
Time and weather factors create the natural patina characteristic for copper.
Spares
Spare glass with gasket 11 002 745 43
LED lamp 3000K 13 583
Lampholder 63 000 187
Gasket glass 83 000 722