BEGA 22 453 Ceiling-Wall-Pillar Luminaire Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
22 453
Ceiling · Wall · Pillar luminaire
Instructions for use
Application
Ceiling, wall and pillar luminaire with safety guard.
A luminaire made of aluminium alloy and impact resistant crystal glass with
light diffusing structures.
Lamp
| Module connected wattage | 3.8 W |
|---|---|
| Luminaire connected wattage | 4.9 W |
| Rated temperature | ta = 25 °C |
| Ambient temperature | ta max = 55 °C |
22 453 K3
| Module designation | LED-0263/830 |
|---|---|
| Colour temperature | 3000 K |
| Colour rendering index | CRI > 80 |
| Module luminous flux | 755 lm |
| Luminaire luminous flux | 385 lm |
| Luminaire luminous efficiency | 78,6 lm / W |
22 453 K4
| Module designation | LED-0263/840 |
|---|---|
| Colour temperature | 4000 K |
| Colour rendering index | CRI > 80 |
| Module luminous flux | 780 lm |
| Luminaire luminous flux | 398 lm |
| Luminaire luminous efficiency | 81,2 lm / W |
Safety
The installation and operation of this luminaire are subject to national
safety regulations. Installation and commissioning may only be carried out by
a qualified electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Product description
Luminaire made of aluminium alloy, aluminium and stainless steel
BEGA Unidure® coating technology
Crystal glass, white inside 2 mounting holes ø 5.5 mm
Distance apart 144 mm 2 cable entries for through-wiring of mains supply
cable ø 7-10.5 mm
Connecting terminal and earth conductor terminal 2.5@
BEGA Ultimate Driver® LED power supply unit
220-240 V x 0/50-60 Hz
DC 176-264 V
BEGA Thermal Switch
Temporary thermal shutdown to protect temperature-sensitive components
Safety class I
Protection class IP 65
Dust-tight and protection against water jets
Impact strength IK06
Protection against mechanical impacts < 1 joule
– Safety mark
– Conformity mark
Weight: 3.0 kg
This product contains light sources of energy efficiency classes C®
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we
recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.
Installation
LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during
installation or relamping.
Undo screws.
Remove luminaire top with glass and gasket.
Lead the mains supply cable through the cable entry into the luminaire back
housing.
Fix luminaire base with enclosed or any other suitable fixing material onto
the mounting surface.
Be sure to use the gasket rings supplied.
In case of installation on a foundation, please observe the following: Wet
concrete can be highly alkaline and must not come into contact with the
luminaire permanently.
We recommend draining the installation area and painting it with insulating
paint.
Make the earth conductor connection and the electrical connection.
Insert glass with gasket and luminaire top.
Make sure that the gasket is in correct position.
Tighten screws firmly.
Cleaning & Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt and deposits.
Do not use high pressure cleaners.
Replacing the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted.
The module can be replaced by qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Inspect and, if necessary, replace the luminaire gaskets.
Defective glass must be replaced.
Close the luminaire.
Spares
| Spare glass | 11 002 665 11 |
|---|---|
| LED power supply unit | DEV-0303/350 |
| LED module 3000 K | LED-0263/830 |
| LED module 4000 K | LED-0263/840 |
| Gasket glass | 83 001 831 |
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>