BEGA 50 181.5 Wall Washer for Indoor Use Instruction Manual
- June 12, 2024
- BEGA
Table of Contents
50 181.5
Technical amendments reserved
Wall washer for indoor use
Instructions for use
50 181.5 Wall Washer for Indoor Use
Application
Wall washer · indoor luminaire with asymmetrical light distribution for
illuminating wall and ceiling surfaces.
The luminaire can be installed with the light distribution opening upwards or
downwards.
Product description
Die-cast aluminum and aluminum housing, finish Colour velvet black
Matt safety glass
Reflector made of pure anodized aluminum 2 mounting holes ø 4.8 mm
Distance apart 128 mm 1 cable entry for mains supply cable up to ø 10,5 mm
Connection terminal 2.5
Earth conductor connection
LED power supply unit
220-240 V x 0/50-60 Hz
DC 170-280 V
BEGA Thermal Switch®
Temporary thermal shutdown to protect temperature-sensitive components
Safety class I
– Safety mark
– Conformity mark
Weight: 0.95 kg
This product contains light sources of energy efficiency classes E
Safety
The installation and operation of this luminaire are subject to national
safety regulations.
Installation and commissioning may only be carried out by a qualified
electrician.
The manufacturer accepts no liability for damage caused by improper use or
installation.
If subsequent modifications are made to the luminaire, the person responsible
for these modifications shall be considered the manufacturer.
Overvoltage protection
The electronic components installed in the luminaire are protected against
overvoltage in accordance with DIN EN 61547.
To achieve an additional protection against e. g. transients, etc. we
recommend separate overvoltage protection components.
You can find them on our website at www.bega.com.
Lamp
| Module connected wattage | 10.2 W |
|---|---|
| Luminaire connected wattage | 12.5 W |
| Rated temperature | ta = 25 °C |
| Ambient temperature | ta max = 30 °C |
50 181.5 K27
| Module designation | LED-0810/927 |
|---|---|
| Colour temperature | 2700 K |
| Colour rendering index | CRI > 90 |
| Module luminous flux | 1460 lm |
| Luminaire luminous flux | 1043 lm |
| Luminaire luminous efficiency | 83,4 lm / W |
50 181.5 K3
| Module designation | LED-0810/930 |
|---|---|
| Colour temperature | 3000 K |
| Colour rendering index | CRI > 90 |
| Module luminous flux | 1510 lm |
| Luminaire luminous flux | 1079 lm |
| Luminaire luminous efficiency | 86,3 lm / W |
50 181.5 K4
| Module designation | LED-0810/940 |
|---|---|
| Colour temperature | 4000 K |
| Colour rendering index | CRI > 90 |
| Module luminous flux | 1570 lm |
| Luminaire luminous flux | 1121 lm |
| Luminaire luminous efficiency | 89,7 lm / W |
Installation
Undo the screws and lift off the luminaire top.
Loosen earth connection (plug connection) between luminaire top and luminaire
base.
LED are high-quality electronic components!
Please avoid touching the light output opening of the LED directly during
installation or relamping.
Lead the mains supply cable through the cable entry of the luminaire base.
Ensure correct directionality towards the area to be illuminated.
Fix luminaire base with enclosed or any other suitable fixing material onto
the mounting surface.
Be sure to use the gasket rings supplied.
Make the earth conductor connection and the electrical connection.
Make earth conductor connection (plug connection) between luminaire top and
luminaire base.
Install the luminaire top, press-on and tighten screws evenly.
Cleaning · Maintenance
Clean luminaire regularly with solvent-free cleansers from dirt.
Replacement of the LED module
The designation of the LED module is noted on a label in the luminaire.
The light colour and light output of BEGA replacement modules correspond to
those of the modules originally fitted.
The module can be replaced by qualified persons using standard tools.
Disconnect the system and open the luminaire.
Please follow the installation instructions for the LED module.
Defective glass must be replaced.
Close the luminaire.
Spares
LED power supply unit
LED module 2700 K
LED module 3000 K
LED module 4000 K
Reflector
BEGA Gantenbrink-Leuchten KG · Postfach 31 60 · 58689 Menden · info@bega.com · www.bega.com