nVent CADDY 107 Series One Hole Strap Hanger Instructions
- June 12, 2024
- nVent Caddy
Table of Contents
INSTRUCTION SHEET
MODEL #107
SERIES
ONE HOLE STRAP HANGER
107 Series One Hole Strap Hanger
PART NO.| PIPE DIA.
---|---
1070075EG| 3/4″
1070100EG| 1″
1070125EG| 1 1/4″
1070150EG| 1 1/2″
1070200EG| 1
SCREWS PROVIDED
USED FOR PVC PIPE ONLY.
-
PLACE PVC PIPE INTO HANGER.
-
MOUNT HANGER ON TO WOOD BEAM WITH SCREWS PROVIDED.
-
These products shall be used only as illstrated and recommended in product instruction sheets (odditional instruction sheets re availoble at www.erico.com). ~Misuse or misappiication may cause failure resulting in possible property damage or bodily injury.
-
These products must be used only in the manner depicted in the illustrations that occompany them and must not exceed load ratings.
-
Failure to observe these specificotions may cause product malfunction resulting in property damoge or bodily injury. ERICO products at the time of shipment are warranted to_conform to any applicable written description furnished to the Buyer by ERICO, and to be fres from defects in materiol and workmanship. NO OTHER WIRRANTY. WETHER EXPRESSED OR WPLED. (INCLUDING ANY WARRANTY OF MERCHANTABILTY OR FITNESS), SHALL EXIST IN CONNECTION WITH THE SALE OR USE OF ANY ERICO PRODUCT.
-
Al instructions must be completely followed to ensure proper and safe operation.
-
Al pipe supports, hangers, intermediate components and structural attachments must ONLY be used as described herein and are NEVER to be used for any other purpose.
NOTE: Al load ratings are for static conditions and do not account for
dynamic loding such as wind, water or seismic loads.
The buyer and/or installer is responsible for: a. Application in conformance
to-all govering codes. b. The integrity of structures to which the products
are attached, including their capabilty of safely accepting the loads imposed,
as evaluated by a qualfied engineer. <. Using appropriate industry standard
hardware as noted above.
SAFETY WARNING:
SAFETY INSTRUCTIONS: Al governing codes and regulations and those required by
the job site must be observed. Aways use appropriate sofety equipment such as
eye protection, hard hat, and gloves as appropriate to the appiicaton.
CADDY, CADWELD, CRITEC, ERICO, ERIFLEX, ERITECH and LENTON are registered
trademarks of ERICO Intemational Corporation.
TECHNICAL SUPPORT:
Www.erico.com
CFs295_B
©2005 ERICO, INC.