BUFFALO CW146 Slimline Heated Multideck Instruction Manual

BUFFALO CW146 Slimline Heated Multideck

Product Information

The Heated Multideck is a versatile appliance designed to display and keep food warm. It features a control panel with various buttons for easy operation. The appliance is equipped with a heating indicator light to indicate when the set temperature is reached and maintained. The unit also includes a night curtain for added convenience.

Pack Contents

• Heated Multideck appliance
• Instruction manual

Installation

1. Remove the appliance from the packaging and remove any protective plastic film or coatings.
2. Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for proper ventilation.
3. Clean the shelves and interior with soapy water before using the appliance for the first time.
4. Set the brakes on the castors to keep the appliance in position.

Operation

To turn on the appliance, ensure the on/off switch is set to “O” and connect it to a mains power supply. Set the on/off switch to “I”. Use the control panel buttons to adjust the settings as needed. The LED heating indicator light will be on during heating up and off when the set temperature is reached. The appliance is now ready for food display and keeping it warm.

Cleaning, Care & Maintenance

For replacing the interior lamp, contact your BUFFALO dealer or a qualified electrician. Regular cleaning of the unit is recommended to prevent odors. If any troubleshooting is required, it should be done by a qualified technician.

Troubleshooting

plugged in correctly and switched on
| Plug or lead is damaged| Replace Plug or lead
| Fuse in the plug has blown| Replace the fuse
| Mains power supply fault| Check mains power supply
Poor heating effect| Poor ventilation| Increase ventilation
| Door is opened frequently or not shut properly| Check door is hooked in place.
| Food too cold or too much food in the appliance| Remove excessive food
| Temperature improperly set| Re-set the temperature
Loud noises| The appliance has not been installed in a level or stable
position| Check installation position and change if necessary
| The appliance is too close to a wall or other object| Move to a well- ventilated position
Odour from the unit| Unit is not cleaned for a long time| Clean the unit thoroughly
The lamp does not illuminate| Lamp needs replacing| Contact a qualified technician
| Light not turned on| Ensure button has been pressed properly

Model
CW146

Safety Instructions

• Position on a flat, stable surface.
• A service agent/qualified technician should carry out installation and any repairs if required. Do not remove any components on this product.
• Consult Local and National Standards to comply with the following:
  • Health and Safety at Work Legislation
  • BS EN Codes of Practice
  • Fire Precautions
  • IEE Wiring Regulations
  • Building Regulations
• Warning! Hot surface! Always wear safety gloves when placing or removing foods.
• This product is only designed to store food temporarily. Do not use for laboratory or industrial purposes.
• DO NOT use jet/pressure washers to clean the appliance.
• DO NOT use the appliance outside.
• DO NOT allow oil or fat to come into contact with the plastic components. Clean immediately if contact occurs.
• DO NOT store products on top of the appliance.
• Always carry, store and handle the appliance in a vertical position and move by holding the base of the appliance.
• Always switch off and disconnect the power supply to the unit before cleaning.
• Keep all packaging away from children. Dispose of the packaging in accordance to the regulations of local authorities.
• If the power cord is damaged, it must be replaced by a BUFFALO agent or a recommended qualified technician in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience or knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance.
• BUFFALO recommend that this appliance should be periodically tested (at least annually) by a Competent Person. Testing should include, but not be limited to: Visual Inspection,Polarity Test, Earth Continuity, Insulation Continuity and Functional Testing.
• BUFFALO recommend that this product is connected to a circuit protected by an appropriate RCD (Residual Current Device).

Introduction
Please take a few moments to carefully read through this manual. Correct maintenance and operation of this machine will provide the best possible performance from your BUFFALO product.

Pack Contents

The following is included:

• Buffalo Heated Multideck
• Instruction manual

BUFFALO prides itself on quality and service, ensuring that at the time of packaging the contents are supplied fully functional and free of damage. Should you find any damage as a result of transit, please contact your BUFFALO dealer immediately.

Installation

1. Remove the appliance from the packaging. Make sure that all protective plastic film and coatings are thoroughly removed from all surfaces.

2. Maintain a distance of 20cm (7 inches) between the unit and walls or other objects for ventilation.
   Note : Before using the appliance for the first time, clean the shelves and interior with soapy water.

3. Set the brakes on the castors to keep the appliance in position.

Operation

Control panel

The control panel is located below the handle on the front of the appliance.

Turn On

1. Ensure the on/off switch is set to O and connect the appliance to a mains power supply.
2. Set the on/off switch to I.
3. Press the button to turn the light On or Off as required.

Setting the Operating Temperature

1. Press the SET button. The previously set temperature is displayed.

2. Press the or button to display the required temperature (Range: 30°C – 80°C).

3. Press the SET button to store the temperature.
   Note for the Heating Indicator: The LED will be on during heating up and off when the set temperature is reached and maintained constantly.

4. The appliance is now ready for food to be displayed and kept warm.

Using the Night Curtain

• If necessary, extend the plastic night curtain downward and hook it into place.

Cleaning, Care & Maintenance

• Switch off and disconnect the appliance from the power supply. Allow to cool down before cleaning.
• Withdraw the door for ease of cleaning.
• Clean the interior of the appliance as often as possible.
• Use warm, soapy water and a damp cloth to clean the appliance.
• Do not use abrasive cleaning agents. These can leave harmful residues.
• Always wipe dry after cleaning.

Replacing the Interior Lamp
Call your BUFFALO dealer or a qualified electrician. The Lamp Assembly is available to purchase as a spare part.

Troubleshooting

A qualified technician must carry out repairs if required.

plugged in correctly and switched on
Plug or lead is damaged| Replace Plug or lead
Fuse in the plug has blown| Replace the fuse
Mains power supply fault| Check mains power supply
Poor heating effect| Poor ventilation| Increase ventilation
Door is opened frequently or not shut properly| Check door is hooked in place.
Food too cold or too much food in the appliance| Remove excessive food
Temperature improperly set| Re-set the temperature
Loud noises| The appliance has not been installed in a level or stable position| Check installation position and change if necessary
The appliance is too close to a wall or other object| Move to a well- ventilated position
Odour from the unit| Unit is not cleaned for long time| Clean the unit thoroughly
The lamp does not illuminate| Lamp needs replacing| Consult a qualified technician
Light not turned on| Ensure  button has been pressed properly

Technical Specifications

Note: Due to our continuing program of research and development, the specifications herein may subject to change without notice.

Model

|

Voltage

|

Power

|

Current

| Temperature range|

Capacity

| Dimensions h x w x d mm|

Weight

| Lamp power
---|---|---|---|---|---|---|---|---
CW146| 230V~

50Hz

| 2000W| 9A| 30°C ~ 80°C| 220L| 1742 x 494 x 600| 67kg| 1.44 x 4 (LED)

Electrical Wiring

This appliance is supplied with a 3 pin BS1363 plug and lead.
The plug is to be connected to a suitable mains socket.

This appliance is wired as follows:

• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E

This appliance must be earthed.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency disconnection being required they must be readily accessible.

Compliance
The WEEE logo on this product or its documentation indicates that the product must not be disposed of as household waste. To help prevent possible harm to human health and/or the environment, the product must be disposed of in an approved and environmentally safe recycling process. For further information on how to dispose of this product correctly, contact the product supplier, or the local authority responsible for waste disposal in your area.
BUFFALO parts have undergone strict product testing in order to comply with regulatory standards and specifications set by international,independent, and federal authorities.

BUFFALO products have been approved to carry the following symbol:

All rights reserved. No part of these instructions may be produced or transmitted in any form or by any means, electronic, mechanical, photocopying, recording or otherwise, without the prior written permission of BUFFALO.
Every effort is made to ensure all details are correct at the time of going to press, however, BUFFALO reserve the right to change specifications without notice.

DECLARATION OF CONFORMITY

Equipment Type
Model

Heated Multideck CW146 (& -E)

Application of Territory Legislation & Council Directives(s)

Low Voltage Directive (LVD) – 2014/35/EU
Electro-Magnetic Compatibility (EMC) Directive 2014/30/EU – recast of 2004/108/EC

EN IEC 61000-6-1:2019
EN IEC 61000-6-3:2021

Restriction of Hazardous Substances Directive
(RoHS) 2015/863 amending Annex II to Directive 2011/65/EU

I, the undersigned, hereby declare that the equipment specified above conforms to the above Territory Legislation, Directive(s) and Standard(s).

+44 (0)845 146 2887

http://www.buffalo-appliances.com/

References

• Buffalo Home Page

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>