SSV WORKS BR-2B65U 2021 Plus Ford Bronco 2 Door 6.5 Inch Rear Speaker-Pod Add-Ons Installation Guide
- June 12, 2024
- SSV WORKS
Table of Contents
SSV WORKS BR-2B65U 2021 Plus Ford Bronco 2 Door 6.5 Inch Rear Speaker-Pod
Add-Ons
Product Information
- Product Name: BR-2B65U
- Manufacturer: SSV Works
- Address: 201 N. Rice Ave Unit A, Oxnard, CA 93030
- Website: www.SSVworks.com
- Phone: 818-991-1778
- Fax: 866-293-6751
Tools Needed for Installation
- T25, T30 Torx Driver
-
1 Phillips Screwdriver
Please read and understand these instructions completely before installation to avoid possible injury, or damage to the accessory or vehicle.
Parts List
- Passenger Rear Door Pod
- Driver Rear Door Pod
- Bracket Pack
- (x2) M6 x Screw
- (x2) M6 Washer
- (x2) #1 Phillips Screw
DISASSEMBLY
- A. Remove the screw located at the bottom of the speaker enclosure.
- B. Removing the two screws securing the bracket to the vehicle. Then remove the two screws securing the bracket to the enclosure.
Note: These 4 factory screws will be re-used for the SSV pods. *This image is of passenger side .
Product Usage Instructions
Step A: Removing the Speaker Enclosure Screw
- Locate the screw at the bottom of the speaker enclosure.
- Remove the screw using an appropriate tool.
Step B: Removing the Bracket from the Vehicle and Enclosure
- Remove the two screws securing the bracket to the vehicle.
- Remove the two screws securing the bracket to the enclosure.
Step C: Securing the Driver Side Bracket to the Driver Side Pod
- Secure the driver side bracket to the driver side pod using the factory two screws.
Step D: Connecting the Pod and Harness
- Hold the pod near its mounting location.
- Connect the factory harness to the pod.
Step E: Securing the Speaker Pod Harness Cover
- Snap the speaker pod harness cover onto the pod, ensuring the harness exits the cover through one of the two reliefs.
- Use the provided Philips screw to secure the cover in place.
Step F: Assembling the Bottom of the Pod to the Vehicle Frame
- Loosely assemble the bottom of the pod to the frame of the vehicle using the provided M6 screw and washer.
Step G: Fully Securing the Pod to the Vehicle
- Install the two factory bolts securing the pod to the vehicle.
- Fully tighten the bottom screw located at the bottom of the pod.
Repeat all steps for the opposite side.
WARRANTY INFORMATION
All SSV Works enclosures are covered by a limited lifetime warranty against defects in material or workmanship. All SSV Works Electronics are covered by a limited 1 year warranty against defects in material or workmanship. All Kicker Speakers are covered by a limited 1 year warranty against defects in material or workmanship. All Kicker Amplifiers are covered by a limited 2 year warranty against defects in material or workmanship. Labor for replacement of defective components is not covered. Contact SSV Works for further warranty information.