AMBIANCE Intrigue 42 Fireplaces Installation Guide
- June 12, 2024
- Ambiance
Table of Contents
Intrigue 42 Fireplaces
GAS COLLECTION
Installation Guide
Intrigue 42 Fireplaces
BTU | EFFICIENCY | VENTING | GLASS |
---|---|---|---|
Max NG | Max PG | Min NG | Min PG |
State** | Type | Max. Height | In & Out Diameter |
Dimensions | Area sq in | ||
39,500 | 39,500 | 18,500 | 18,500 |
Pure vision Robax | 26” x 35” | 910 | |
DIMENSIONS | MINIMUM FRAMING DIMENSIONS | BLOWING | **MANTEL |
SHELF CLEARANCES
---|---|---|---
Height| Depth| Width| Height| Depth| Width|
Type| PCM| 9-inch shelf**
34.5”| 20”| 40.875”| 44.5”| 20”| 41.875”| Variable speed| 150| 12.5’’
Framing and Clearances
CLEARANCES
Top of unit face to header (cement board may be used in this area).| 10’’
(254mm)
From unit left & right sides and back| 1/2’’ (13mm)
To flooring| 0’’ (0mm)
Unit top to ceiling| 31’’ (787mm)
Side of unit face to adjacent sidewall| 3’’ (76mm)
Mantel 9’’ (229mm) deep from top of fireplace| 12-1/2’’ (318mm)
Top of fireplace to 1’’ (25 mm) trim| 10’’ (254mm)
Mantel Requirements
WARNING
TOP STAND-OFF BRACKETS MUST BE ASSEMBLED AND ATTACHED TO FIREPLACE. DO NOT
REMOVE. STAND-OFF BRACKETS ARE NOT LOAD BEARING
Non-Combustible Zone:
Rigid Pipe: 1’’ (25 mm) above elbow for entire width and depth (behind
header) of fireplace.
Flexible Venting: 1’’ (25 mm) above elbow for entire width and depth
(behind header) of fireplace.
CLEARANCES
Top of unit face to header (cement board may be used in this area).| 10’’
(254mm)
From unit left & right sides and back| 1/2’’ (13mm)
To flooring| 0’’ (0mm)
Unit top to ceiling| 31’’ (787mm)
Side of unit face to adjacent sidewall| 3’’ (76mm)
Mantel 9’’ (229mm) deep from top of fireplace| 12-1/2’’ (318mm)
Top of fireplace to 1’’ (25 mm) trim| 10’’ (254mm)
Typical Installation Options
IMPORTANT
The horizontal heat shield included with this fireplace must be installed when
incorporating minimum horizontal venting. This applies to Nat. and LP minimum
horizontal venting configurations.
Horizontal vent heat shield not shown in illustrations below for clarity
purposes only.
Typical Horizontal Installation| Typical Corner Installation|
Typical Vertical Installation
---|---|---
| |
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>