urban ambiance UHP4331 Contemporary Bath Light Instruction Manual
- June 12, 2024
- urban ambiance
Table of Contents
UHP4331 Contemporary Bath Light
Instruction Manual Installation Instructions: UHP4331
UHP4331 Contemporary Bath Light
| PART DESCRIPTION| QUANTITY
---|---|---
1-LIGHT| 2-LIGHT| 3-LIGHT| 4-LIGHT
A| Fixture| 1| 1| 1| 1
B| Glass shade| 1| 2| 3| 4
C| Socket cover| 1| 2| 3| 4
D| Socket ring| 1| 2| 3| 4
HARDWARE CONTENTS (not actual size)
**** Safety Information
Please read and understand this entire manual before attempting to assemble,
operate or install the product.
CAUTION: Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
CAUTION: Risk of fire. Min. 90°C supply conductors. Consult a qualified
electrician to ensure correct branch circuit conductor.
WARNING: If any Special Control Devices are used with this fixture,
follow instructions carefully to assure full compliance with N.E.C.
requirements. If there are any questions, contact a qualified electrical
contractor.
CAUTION: All glass is fragile. Use care when handling glass shades and
bulbs.
Preparation
- Before beginning installation, make sure all parts are included using the contents diagrams from page 1. If any part is missing or damaged, do not attempt to assemble, install or operate the product.
- Estimated assembly time: 30 minutes.
- Tools required for assembly (not included): Phillips screwdriver, pliers, wire stripper, safety glasses, electrical tape, ladder.
Care and Maintenance
Shut off main power supply before cleaning product or changing light bulbs. To clean, wipe with damp cloth. Do not use abrasive cleaners or cleaners that contain alcohol.
Assembly Instructions
la. Attach the metal back plate (CC) onto the outlet box using the mounting
screws supplied with the outlet box (not provided). Adjust it so it is
parallel with the ceiling or wall surface. Tighten securely. lb. Line up mounting holes on the back plate (CC) with screw holes
on the outlet box.
Using the back plate (CC) as a template, locate the mounting slots on the
outer edges of the back plate (CC).
Drill pilot holes for the Plastic anchors (FF). Remove back plate from the
outlet box. Press the Plastic anchors (FF) into the
pilot holes. Install the back plate (CC) to the outlet box using the mounting
screws (not provided).
Once back plate (CC) is installed, drive the provided Anchor screws (EE) into
the installed Plastic anchors (FF).
2. Strip 3/8″ of insulation from the electrical wire ends. Using wire nuts
(BB), connect the WHITE fixture wire to the WHITE supply wire from the outlet
box; connect the BLACK fixture wire to the BLACK supply wire from the outlet
box.
Connect the fixture ground wire and supply ground wire using a wire nut or by
fastening it to the ground screw on the metal back plate. Push all of the wire
connections careful into the outlet box.3. Attach the fixture (A)
to the metal back plate using the screws provided (DD).
Tighten the fixture against the mounting surface.
Fixture can mount in glass UP or glass DOWN position. 4. Attach the glass shade (B) and socket cover (C) to the fixture
(A). Use the socket rings (D) to secure modestly tight.
Thread the lamps (not included) into the fixture sockets. Use 100-watt MAX
incandescent medium base lamp, SBCFL or SB LED. Questions?
Call our Customer Care Team at
1-855-303-4229
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>