AMBIANCE FIREPLACES Intrigue 36 Gas Collection Owner’s Manual

October 30, 2023
AMBIANCE FIREPLACES

AMBIANCE FIREPLACES Intrigue 36 Gas Collection

AMBIANCE FIREPLACES Intrigue 36 Gas Collection

DIMENSION

Dimension
Dimension

BTU                                       EFFICIENCY VENTING| GLASS
---|---
Max NG
27,000| Max LP
27,000| Min NG
19,000| Min LP
21,000| Energuide Steady State
71.13%        75.73%| Type
Direct| Max. Height
35 feet| In & Out Diameter
4” & 7”| Type
Pure vision Robax| Dimensions Area sq in
28” x 19.63”     550
DIMENSIONS                                   FRAMING DIMENSIONS| BLOWING| MANTEL SHELF CLEARANCES
---|---|---
Height
33.5”| Depth
19.3”| Width
35.6”| Height
43.25”| Depth
18.5”| Width

35.63”

| Type
Variable speed| CFM
150| 6-inch shelf
18.25’’

Framing and Clearances

CLEARANCES

Top of unit face to header (cement board may be used in this area).| 10’’ (254mm)
From unit left & right sides and back| 1/2’’ (13mm)
To flooring| 0’’ (0mm)
Unit top to ceiling| 31’’ (787mm)
Side of unit face to adjacent sidewall| 3’’ (76mm)
Mantel 9’’ (229mm) deep from top of fireplace| 12-1/2’’ (318mm)
Top of fireplace to 1’’ (25 mm) trim| 10’’ (254mm)

Ventilation Framing

Ventilation framing dimensions are based on Duravent venting components.
If other third party venting components are used, refer to the installation instructions from the third party manufacturer for installation information. The following critical dimensions must be maintained regardless of venting manufacturer:

Item Critical Dimensions
Distance from ceiling to horizontal pipe 4’’ (10.16 cm)
Thimble framing dimensions 9’’ (22.86 cm) W x 10’’ (25.4 cm) H

11.3 Ventilation Framing

IMPORTANT
Vent cap location must be in compliance with guidelines in Section 10.4 of this manual.

WARNING
DO NOT RECESS VENT CAP INTO WALL OR SIDING.

11.3 Ventilation Framing

Clearances to Combustibles

WARNING: Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance may result in property damage or personal injury or loss of life.

WARNING: TOP NAILING FLANGE EXTENSION MUST BE ASSEMBLED AND ATTACHED TO FIREPLACE. DO NOT REMOVE. TOP NAILING FLANGE EXTENSION IS NOT LOAD BEARING

Mantel Clearances
Sidewall Clearances

Maintain a minimum of 4’’ (10.16 mm) clearance from the side of the glass door to sidewalls or mantel supports.

Sidewall Clearances

Optional Hearth Installation

Any hearth extending 12» or less from the front fireplace must be constructed of non-combustible material. A hearth is not required for installation.

Customer Support

Ambiance® Fireplaces & Grills www.ambiancefireplaces.com

Logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals