kogan KA19LICEMKA 12kg Ice Cube Maker User Guide

kogan KA19LICEMKA 12kg Ice Cube

SAFETY & WARNINGS

Ensure to read all instructions and warnings in this user guide prior to first use. Retain this user guide for future reference.

• This ice cube maker is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge unless they have been given supervision or instruction concerning the use of the ice cube maker by a person responsible for their safety.
•  This ice cube maker is made for indoor household use only.
• Do not use this ice cube maker outdoors.
• The internals of the ice cube maker should never exceed 45°C.
• The operating environment for this ice cube maker is between 5­35°C.
• Do not turn the ice cube maker upside down. This can cause the compressor or refrigerating system to operate incorrectly.
• Do not use with an extension cord unless necessary. If using, ensure it is suitably rated and it is handled safely as is the ice cube maker’s own power cord.
• Do not allow the power cord to be exposed to water, heat, or direct sunlight.
• Do not allow the power cord to overhang where it can be pulled or otherwise be damaged or pose a hazard.
• This ice cube maker contains no user-serviceable parts. If it suffers any failure or damage, consult the “Troubleshooting” section of this user guide. If the issue is not resolved, stop use immediately and contact help.Kogan.com for assistance.
• Do not touch the evaporator while making ice to avoid frostbite. · Ensure the power cord is unplugged when not in use.
• Never store or use gas and other flammable articles near the ice cube maker.

OVERVIEW

1. Top lid
2. Evaporator
3. Air outlet
4. Viewing window
5. Ice tray
6. Ice shovel
7. Ice basket
8. Ice scoop
9. Control panel
10. Max level indicator
11. Water reservoir
12. Drain plug
13. Infrared LED
14. Infrared receiver

Control panel

ADD WATER

| ICE FULL| ICE|

ON/OFF

---|---|---|---

Illuminates when the water reservoir is empty.

| Illuminates when the ice basket is full| Blinks in standby mode, solid when operating.|

Start or stop the ice cube maker.

BEFORE USE

Unpacking

Unpack the ice cube maker, then check to ensure that all the components are included. If components are missing, contact help.Kogan.com for assistance.

Cleaning

It is strongly recommended to clean the ice cube maker before first use.

• Remove the ice basket.
• Open the drain plug. Clean the interior with a soft cloth soaked with warm water and vinegar. Rinse with fresh water and drain.
• Wash the ice basket and ice scoop in warm soapy water. Rinse and dry.
• Clean the exterior of the ice maker with a soft damp cloth. Use a mild dishwashing soap if necessary.

Placement

Place the ice cube maker on a stable, level surface with at least a 25cm clearance from heat sources (for example, ovens, heaters, and corrosive gases). Before first use, wait for at least two hours to allow the fluids in the compressor to settle. For subsequent uses, wait for at least 30 minutes to allow the fluids in the compressor to settle after the ice cube maker is moved or transported.

Notes:

• Do not turn the ice cube maker upside down.
• During winter, allow the appliance a few hours to warm to room temperature before plugging in.

OPERATION

Ensure that the drain plug at the bottom of the water reservoir is closed well. Before first use, wait for at least two hours to allow the fluids in the compressor to settle.

1. Plug the ice cube maker into the wall outlet and turn the outlet on. The “ICE” indicator will blink.

2. Open the top lid and remove the ice basket.

3. Fill the water reservoir with drinking water between 8–25°C.
   Note:
   Do not fill the water reservoir with hot water. It is best to fill it with water that is room temperature or colder.

4. Place the ice basket in and close the top lid.

5. Press the “ON/OFF” button and the “ICE” indicator will turn solid. One ice-making cycle will take approximately 7–15 minutes, depending on the ambient temperature and water temperature.
   • The ice-making cycle starts with water being pumped into the ice tray situated below the evaporator. Over the next 7–15 minutes, ice will form in the evaporator.
   • Once completed, the ice tray will tilt backwards and the remaining water in the ice tray is drained back into the water reservoir.
   • The ice cubes are then dropped from the evaporator and pushed forward into the ice basket by the ice shovel.
   • The ice tray will automatically move back into position under the evaporator and start the next cycle.

6. When the desired amount of ice is made, press the “ON/OFF” button to stop the ice-making process. Turn off the outlet then unplug the power cord. Open the top lid and collect the ice using the ice scoop.

Ice full indicator

The “ICE FULL” indicator will illuminate when the ice basket is full, and the ice-making cyclewill stop automatically.
Gently remove the ice from the ice basket with the ice scoop. About five seconds later, the ice cube maker will resume making ice automatically.

Add water indicator

The “ADD WATER” indicator will illuminate when the water reservoir is out of water. The ice-making cycle will stop automatically.

1. Remove the ice basket and add water into the reservoir.
2. Place the ice basket into the ice cube maker then press the “ON/OFF” button to restart the ice-making cycle.

CLEANING & CARE

It is recommended to clean the ice maker and replace the water once a week. Ensure the ice cube maker is turned off, unplugged, and at room temperature before cleaning.

1. If there is residual water found in the ice tray, gently push the ice tray back so that all water drains into the water reservoir.

2. Move the ice cube maker 75mm away from the surface it is used on and open the drain plug to drain out excess water.
   

3. Remove the ice basket.

4. Clean the interior with a soft cloth soaked with warm water and vinegar, then rinse with fresh water and drain.

5. Replace the drain plug firmly. Wash the ice basket and ice scoop in warm soapy water. Rinse and dry.

6. Clean the exterior with a soft damp cloth. Use a mild dishwashing soap if necessary, then wipe dry.

Notes:

• Do not use organic solvents, boiled water, detergent, strong acid, or strong alkali to clean this ice cube maker.
• Do not clean the evaporator.

Storage

If the ice cube maker will not be used for an extended period, ensure the water reservoir is empty, and all components are dry.
Store in a cool, dry place, away from direct sunlight.

TROUBLESHOOTING

cube maker and clean.
The pump has malfunctioned.| Stop use immediately and contact help.Kogan.comfor assistance.
The “ICE FULL” indicator is illuminated.| The ice basket is full.| Remove ice from the ice basket.
The infrared LED and receiver are not working.| Clean the infrared LED and receiver then restart the ice cube maker.
The “ADD WATER” and “ICE FULL” indicators are illuminated.| The ice tray is not in the correct position.|

• Ensure the ice tray is unobstructed.
• Unplug, reconnect, and restart the ice cube maker.

The ice cubes are clumping together.| The ice-making cycle is too long.|

1. Turn off the ice cube maker to stop making ice.
2. **** Wait until the ice inside melts before restarting.

The water temperature is too low.| Refill the water reservoir with water between 8–25°C.
The ice cube maker is operating but not making ice.| The ambient temperature or water temperature is too high.|

• Ensure the ambient temperature is between 5–32°C.
• Refill the water reservoir with water between 8–25°C.

The refrigeration system is leaking.| Stop use immediately and contact help.Kogan.com for assistance.
The refrigeration system is blocked.| Stop use immediately and contact help.Kogan.com for assistance.
Poor icemaking results| There is poor heat dissipation.| Ensure there is at least a 25cm clearance on all sides of the ice cube maker for proper ventilation.
The water temperature is too high.| Refill the water reservoir with water between 8–25°C.
The ambient temperature is too high.| Ensure the ambient temperature is between 5–32°C.

Ice is getting stuck.

| Occasional occurrence in low temperatures.| The ice cube maker will automatically enter standby after three instances of ice sticking and run again automatically after 20 minutes.

If the above steps do not resolve an issue you are facing, contact help.Kogan.com for assistance.

SPECIFICATIONS

Need more information?
We hope that this user guide has given you the assistance needed for a simple set-up.
For the most up-to-date guide for your product,as well as any additional assistance you may require, head online to help.kogan.com

References

• Kogan Help Centre

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>