GE Lighting B0B26QYS7T CYNC Indoor Smart Plug User Manual

Plug Into Smart Control

3 Ways to Set Up Your Smart Plug

 Start with the CYNC App

1. Plug your Smart Plug into on outlet
2. Download the CYNC App.
3. Add the Smart Plug to the CYNC App. Tip Having trouble connecting? Move your Smart Plug doser to your router to commission
4. Add your Smart Plug and other C by GE or CYNC devices to the some room or group in the CYNC App to enable whole room/group control
5. To set up voice control with Amazon Alexa or Google Assistant, enable CYNC / C by GE within your voice assistant app and And your devices

Get started with Amazon Frustration Free Setup

If you selected Frustration Free Setup during checkout easily pair your CYNC Plug with your Alexa voice assistant.

1. Plug in your Smart Plug.
2. If Alexa says, “New plug found”, you can begin using your Smart Plug with Alexa. Otherwise, go to step 3.
3. Say, “Alexo, discover my devices”. Once your Smart Plug is discovered you can begin using your Plug with Alexa.

Get started using the Google Home App

1. Plug your Smart Plug into an outlet
2. Open Google Home app. Plug.
3. Click notification to set up device and select CYNC /C by GE Smart
4. Assign your Smart Plug to o room.

FCC Compliance Statement Compliance Notice:

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

This device complies with part 15 of FCC rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.

Changes or modifications that are not expressly approved by the manufacturer could void the user’s authority to operate the equipment
RF Exposure Information:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. In order to avoid the possibility of exceeding the FCC radio frequency exposure limits, human proximity to the antenna shall not be less than 8 inches during normal operation.
RF Exposure Statement:
This equipment complies with IC RSS-102 radiation exposure limits set forth for an uncontrolled environment. This transmitter must be installed to provide a separation distance of at least 8 inches from all persons and must not be collocated or operating in conjunction with any other antenna or transmitter.
CAUTION – High Voltage – Disconnect power supply before servicing Operation temperature: 0-40°C For Control of Electronic Ballast, CFL, LED Lamps Type 1 Enclosure IP20 Pollution Degree 2 Impulse Voltage:1500V Indoor use only. C by GE is a trademark of General Electric Company. Used under trademark license.
Models CPLGSTDBLWVBSS1P PK-0006399-2

Start with the CYNC App when pairing your Smart Plug with other CYNC or C by GE devices. For setup help, visit supportgelighting.com or call 1-844-302-2943.
Note: Please make sure your system is up-to-date and you update the firmware when prompted for the best experience.

Read User Manual Online (PDF format)

Download This Manual (PDF format)

Download this manual  >>