NORDIC HOME FT-561 Metal Floor Stand Fan User Manual

FT-561, FT-562
Metal Floor Stand Fan
User Manual

Thank you for choosing Nordic Home!

Safety instructions

1. The appliance may only be used as described in the manual. Other use may void the warranty.
2. Before connecting the product to the mains voltage, check that the voltage on the product matches the mains voltage.
3. Do not use this product with a damaged plug, power cable, housing, or after a mal function or if it has suffered fall damage or if it has suffered other type of damage.
4. This product can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
5. Children shall not play with this product.
6. Cleaning and user maintenance should not be made by children unless they are older than 8 years and supervised.
7. Keep the product and its cable out of reach of children less than 8 years of age.
8. Ensure that the product is disconnected from the mains before removing the fan guard.
9. Do not let the power cable hang over a sharp edge of a table or a counter (furniture).
10. Do not let it not come into contact with any hot surface.
11. Protect it from pinch damage.
12. Never place or wind the power cable around the product. The power cable must never come in contact with the fan during usage.
13. Only use the product with a fully unwound power cable. Danger of overheating and fire!
14. Do not pull the power cable to disconnect the power plug. Pull the power plug straight out from the wall when disconnecting.
15. The power plug must be easy to access at all times, so the power plug can be disconnected as quickly as possible.
16. Do not attempt to service this product or its cable yourself, instead please contact a fully qualified electrician or the retailer or our support. Improper repairscan expose the user to danger!
17. Always disconnect the product from the mains after each use or when adjusting itor moving it from one location to another, and before you clean the product.
18. Do not leave the product unsupervised. Disconnect the product from the mains before leaving your home.
19. Do not leave the product unattended near children, vulnerable persons or pets.
20. Do not cover the product.
21. Never use or touch the product with wet or moist hands. Risk of personal injury!
22. Make sure the product is placed on an even, flat, stable and dry surface to protect the product from overturning during usage. Do not use the product on uneven surfaces.
23. Do not hang or mount the product on a wall or the ceiling. Do not place the product near curtains or plants or in their vicinity.
24. Maintain a safety distance of at least 50 cm from the product to other objects.
25. Do not place the product or any parts of the product near an open flame, heat ventilation, cooking stove or other heating appliances or other products that produce heat. Keep the product away from flammable objects.
26. Do not use the product in flammable atmospheres (e.g. in the vicinity of combustible gases or sprays). Fire hazard!
27. Do not use the product without fully assembled fan guard. Risk of personal injury! The fan guard must be securely closed during use.
28. Never touch moving parts. Avoid contact with moving parts or running fan blades with any part of your body or your hair. Risk of personal injury and damage to the product!
29. Never insert fingers, pencils or other objects through the fan guard when the product is in use or when it is disconnected from the mains. Do not insert any foreign objects into the fan guard or in any opening of the product. Risk of personal injury, electric shock and damage to the product!
30. This product may not be used in bathrooms, showers, wash bowl, swimming pool or in the immediate vicinity of water, damp or other liquids etc. or where there is a risk of immersion into liquid or splashing of liquids onto the product.
31. Do not immerse the product, its power plug or cable in water or other liquids.
32. Do not use the product outdoors.
33. The product is for household use only.
34. The product is not for commercial or industrial use.
35. Do not operate the product with an extension cable or interposed timer switches or with other means which can switch the device automatically on or off as this can cause overheating and fire.
36. Do not use this fan with any external speed control device to reduce the risk of electric shock, overheating and fire.
37. Do not use the product close to windows. Rain may create electrical hazard! Risk of fatal injury!
38. Never place the product where it could be subject to direct sunlight or excessive dust.
39. Never place the unit where it could be subject to mechanical vibration or shock.
40. During assembling or disassembling the product may not be connected to the mains.
41. Only connect to the mains after the product has been fully and correctly assembled.
42. Do not place the power cable under a cover or under a carpet or cover the cable with objects. The power cable should not cross any passage for people to avoid tripping hazard or product damage.
43. Keep all packaging away from children (plastic bag, carton, plastic foam, etc.).
44. Never try to open up or repair the device by yourself as this can void the warranty and could also result in damage to property and personal injury. Instead please contact a fully qualified electrician or the retailer or our support.
45. Save these instructions.

1. Fan guard (front)
2. Fan guard screw
3. Fan blade
4. Screw for fan blade
5. Screws for fan guard (4x)
6. Fan guard (back)
7. Handle
8. Motor shaft
9. Speed control
10. Activate/deactivate oscillation
11. Motor
12. Extension pipe| 13. Thumb screw for extension pipe
14. Base pipe
15. Fan base
16. Weight for the base
17. Washer
18. L-shaped screw
19. Small thumb screw (for easy adjusting)
20. Small screw
21. Pipe fixture
22. Long screw
23. Big thumb screw
---|---

Assembly

1. Put and fasten the L-screw (18.) through the washer (17.), weight for the base (16.) and the fan base (15.).
2. Fasten the extension pipe (12.) onto the fan base (15.).
3. Loosen the screws (19.), (20.), (22.) and (23.).
4. Place the motor (11) on the upper part of the pipe fixture (21.).
5. Fasten the screws (19.), (20.), (22.) and (23.).
6. Use the thumb screw (19.) to adjust the fan angle.
7. Remove the protective plastic from the motor shaft (8.).
8. Loosen the 4 fan guard screws (5.). See image “AB”.
9. Place the fan guard (back) (6.) on the motor (11.) and fasten 4 fan guard screws (5.). Make sure the fan guard is placed securely against the motor and the handle (7.) is at the top.
10. Loosen the screw for the fan blade (3.). Place the fan blade onto the motor shaft (8.).
11. Align the screw for fan blade (3.) with the flat groove on the motor shaft (8.). Fasten the screw for fan blade (4.). Ensure that the fan blade (3.) is fixed on the motor shaft (8.).
12. Remove the fan guard screw (2.) from front fan guard (1.). Open the fan guard’s clamps (1.), put the fan guards together and squeeze the clamps together. Fasten the fan guard screw (2). See image “EF”.
13. Double check that fan guard is securely mounted.
14. The fan should now be fully assembled, check that the fan is stable.
15. Loosen the thumb screw for extension pipe (13.). Fasten it at desired height.
16. Place the fan on a stable, flat, dry surface.
17. Check that the fan is switched off.
18. Insert the power plug of the fan into the mains. The fan is ready to operate.

Speeds and power
“0”= OFF, “I”= low speed, “II”= medium speed, “III” = high speed.
To switch off the fan, set the switch to position “0” (Off) and pull out the power plug from the mains.
Oscillation
Push and pull the oscillating knob (10.) to activate or deactivate oscillation (swinging motion).
Angle adjustment
Caution: The fan should always be switched off and disconnected from the mains when making angle adjustments.
Use the thumb screw (23.) to adjust the fan angle. Loosen the screw, adjust and then fasten the screw.

Cleaning and maintenance

Before cleaning, switch off the device and disconnect the product from the mains. Never clean this product when it is connected to power!
Use a soft dry cloth to clean the product.
Keep the ventilation on the back of the fan free from dust.
Do not use detergents, abrasive cleaning products or polishing cleaning products to clean.
They can damage the surface of the fan.
For storing the product we recommend using the original carton. Store in a cool and dry place protected from dust.
Properties
Rated voltage: 220-240V ~ 50Hz
Power: 50 W [FT-561], 60 W [FT-562]

Support
More product information can be found at www.deltaco.eu.
Disposal of the packaging
The carton can be used for storing or moving the product. Dispose of the packing material by recycling it, according to your local regulations.

SIMPLIFIED EU DECLARATION OF CONFORMITY

The simplified EU declaration of conformity referred to in Article 10(9) shall be provided as follows: Hereby, DistIT Services AB declares that the radio equipment type wireless device is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: www.aurdel.com/compliance/

Disposal of electric and electronic devices EC Directive 2012/19/EU This product is not to be treated as regular household waste but must be returned to a collection point for recycling electric and electronic devices. Further information is available from your municipality, your municipality’s waste disposal services, or the retailer where you purchased your product.

DistIT Services AB, Glasfibergatan 8, 125 45 Älvsjö, Sweden
DistIT Services AB, Suite 89, 95 Mortimer Street, London, W1W 7GB, England

References

• aurdel.com/compliance/
• deltaco.eu

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>