FALCON RIDGE Arctic Cat Wildcat XX Full Front Windshield Instruction Manual
- June 3, 2024
- FALCON RIDGE
Table of Contents
FALCON RIDGE Arctic Cat Wildcat XX Full Front Windshield
Instructions for Installation and Care of Arctic Cat
NOTICE: Please check contents of package for any damage and make sure all parts fit correctly and you are happy with the product before removing protective film. Once the film is removed you cannot return the product for a full refund
- Be sure to read these instructions thoroughly before opening and installing the Wildcat XX Polycarbonate Windshield.
- Check over the parts included in the cartons with the parts list shown below:
- Velcro Strap Clamps 4 each
- 52” Side Bulb Rubber Gasket 1 each
- 6” Adhesive Padding Strips 2 each
- Lexan Windshield 1 each
- Start by pulling it out of the box, find a clean area to lay it down, and install the hardware. Begin by peeling off the protective film. Next take the 52” piece of rubber gasket and starting at one end firmly place along entire bottom edge of the Windshield as shown in the photo below
- Before you install the windshield on you Wildcat place the two strips of adhesive padding on the top of the intrusion bars as shown in the photo below
- You are now ready to install the windshield on your roll cage.
- Take the four Velcro clamps and place them through the square holes then wrap the strap around the roll cage and under the wire as shown in the photo below
- Then just Pull the strap back around the bar and attach it to the Velcro.
- Now you are ready to take it out and enjoy. To clean the windshield, always clean using a liquid of some sort to decrease the chance of scratches. We recommend using microfiber cloths that are readily available at any dollar store. Any window cleaner will work fine; just remember to use a soft clean rag or micro-fiber cloth to clean it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>