Minka Lavery 2785-695 Chelsea 5 Light Soft Brass Chandelier with White Silk Shades Instruction Manual

Minka Lavery 2785-695 Chelsea 5 Light Soft Brass Chandelier with White

Silk Shades

Product Information

The product is a light fixture with item number 2785-695, manufactured on January 20th, 2022. The fixture can be mounted on a junction box and comes with a mounting plate, ground screw, and mounting screws. The fixture has a rod assembly and three rods (F1, F2, and F3) that can be threaded to adjust the hanging height. The fixture supports five candelabra base bulbs up to 60 watts each or their CFL/LED equivalent.
WARNING: SHUT POWER OFF AT FUSE OR CIRCUIT BREAKER .

INSTALLATION INSTRUCTIONS

MOUNTING THE FIXTURE (Fig.1)

1. Shut off power at the fuse box or circuit breaker box and remove the old fixture including the mounting hardware.

2. Carefully unpack your new fixture and lay out all the parts  in a clean area. Take care not to misplace any small parts  necessary for installation.

3. Secure rod (H) onto all thread (I) on fixture body.

4. Place rod assembly (G) over all thread (E) on rod (H). Carefully pass the wires through rod (H) during assembly.

5. Determine the desired hanging height and thread rods (F1, F2 and F3) to the all thread (E) of rod (H). Attach canopy (C) by threading onto rod (F1). Carefully feed wires through each rod as you assemble.
   Note: Remove all thread, if installing with one 6″ rod only.

6. Attach mounting plate (A) to junction box (Not included) with mounting screws (B) (Size: #8-32N*L0.5″). The side of the mounting plate (A) marked “GND” and two convex points must face out.

CONNECTING THE WIRES (Fig. 2)

1. Connect the electrical wires as shown in fig 2, making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided.
2. Tuck wire connectors neatly into the junction box.

FINISHING THE INSTALLATION (Fig.1)

1. Place canopy (C) over mounting plate (A) and secure with screws (D).
2. Place candle covers (K) over sockets (J).
3. Place cloth shade (L) onto candle cover (K). Adjust cloth shade (L)if necessary.
4. Install (5) five candelabra base bulbs (M) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification
   Warning: DO NOT EXCEED THE MAXIMUM WATTAGE RATING!

Your installation is now complete. Return power to the  junction box and test the fixture.
Note: Illustration (Fig.1) on this manual is for installation purposes only. It may or may not be identical to the fixture purchased.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>