Minka Lavery 2732-709 Graham Avenue 13.5 Inch 2 Light Smoked Iron and Brushed Nickel Vanity Light Instruction Manual

June 12, 2024
MINKA LAVERY

Minka Lavery 2732-709 Graham Avenue 13.5 Inch 2 Light Smoked Iron and

Brushed Nickel Vanity Light

Minka-Lavery-2732-709-Graham-Avenue-13.5-Inch-2-Light-Smoked-Iron-and-
Brushed-Nickel-Vanity-Light-PRODUCT

Product Information

The product being installed is Item#2732-709, a fixture that is intended to be wall-mounted. The installation manual is dated February 17, 2022. The product comes with a mounting plate, two mounting screws, a ground screw, and a metal ring to secure the glass shade. The fixture can accommodate two candelabra base bulbs of up to 60 watts each or CFL or lead equivalent (not included).

Product Usage Instructions

MOUNTING THE FIXTURE

  • Shut off power at the fuse box or circuit breaker box. Remove the old fixture including the mounting hardware.
  • Carefully unpack your new fixture and lay out all the parts in a clear area. Take care not to misplace any small parts necessary for installation
  • Loosen screws (D) to remove mounting plate (A) from fixture body (C).
  • Position mounting plate (A) on the wall and mark the location of four drywall anchors (I). Pre-drill the holes for the drywall anchors (I). Insert the drywall anchors (I) into the wall.
  • Attach mounting plate (A) to junction box (not included) with mounting screws (B) (Size: #8-32N*L0.5). The side of the mounting plate (A) marked GND and two convex points must face out.
  • Place woodscrews (J) through holes into the drywall anchor (I) to secure the mounting plate (A)

CONNECTING THE WIRES

  •  Making sure that all wire connectors are secured. If your junction box has a ground wire (green or bare copper), connect the fixture’s ground wire to it.
  • Otherwise, connect the fixture’s ground wire directly to the mounting plate (A) using the green screw provided. After the wires are connected, tuck them carefully inside the junction box.

FINISHING THE INSTALLATION

  • Place fixture body (C) over the mounting plate (A) and secure with screws (D).
  • Place glass shade (F) over a socket (E) and secure with a metal ring (G).
  • Install (2) two candelabra base bulbs (H) up to 60 watts each or CFL or LED equivalent (not included) in accordance with the fixture specification
  • DO NOT EXCEED THE MAXIMUM WATTAGE RATING! Return power and test the fixture.

Minka-Lavery-2732-709-Graham-Avenue-13.5-Inch-2-Light-Smoked-Iron-and-
Brushed-Nickel-Vanity-Light-FIG-1 Minka-Lavery-2732-709
-Graham-Avenue-13.5-Inch-2-Light-Smoked-Iron-and-Brushed-Nickel-Vanity-Light-
FIG-2

Note: The illustration (Fig.1) in this manual is for installation purposes only. It may or may not be identical to the fixture purchased.

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

MINKA LAVERY User Manuals

Related Manuals