Sea Gull Lighting Vado Post 1-Light Outdoor Post Lantern Instruction Manual
- June 12, 2024
- Sea Gull Lighting
Table of Contents
Sea Gull Lighting Vado Post 1-Light Outdoor Post Lantern
PRODUCT INFORMATION
Product Name: Vado Post
Model Number: VADO_OD_POST
Part Number: 8231101 1.0
General Product Information
This product is safety listed for wet locations. This instruction shows a
typical installation.
CAUTION – RISK OF FIRE: This product must be installed in accordance with
the applicable installation code by a person familiar with the construction
and operation of the product and the hazards involved.
SAVE THESE INSTRUCTIONS
For installation, follow the steps below:
Install the Fixture
- Attach the post to a suitable base using the post screw (2).
- Insert the cover screw (1A) into the post (2).
- Attach the shade (7) to the socket shade base (5).
- Insert the lamp (4) into the socket shade base (5).
- Attach the socket shade base (5) to the post (2).
Note: This is a typical installation guide. If you are not familiar with electrical work, please consult a professional electrician for installation.
Contact Information: Generation Lighting 7400 Linder Ave., Skokie, IL 60077 T 847.410.4400 |
- F 847.410.4500
- Website: www.generationlighting.com.
GENERAL PRODUCT INFORMATION
- This product is safety listed for wet locations.
- This instruction shows a typical installation.
CAUTION – RISK OF FIRE
This product must be installed in accordance with the applicable installation
code by a person familiar with the construction and operation of the product
and the hazards involved. Use minimum 90°c supply conductors.
OVERVIEW
Install the Fixture
- Connect the fixture to a suitable ground in accordance to local electrical codes.
- Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
- Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
- Secure the fixture to the post with post screws.
- Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information.
- Screw the shade into the shade base.
- Place the cover onto the fixture, align the cover holes to the fixture holes, and secure it in place with the cover screws.
©2023 Visual Comfort & Co., L.L.C. All rights reserved. The Visual Comfort & Co. logo is a registered trademark of Visual Comfort & Co. Visual Comfort & Co. reserves the right to change specifications for product improvements without notification.
- GENERATION LIGHT IN G
- 7400 Linder Ave, Skokie, IL 60077
- T R47410 4400
- E RAT MIO ASOC
- www.generationlighting.com.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>